Hearth and Home Technologies WSK-21-W Installation And Operating Instructions

Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
Check Contents of Shipping Carton
Compare contents of carton in Figure 1 with the actual parts
received. If any parts are missing or damaged, contact
your dealer before beginning installation. DO NOT install
a damaged wall switch kit.
CAUTION! Do not install damaged components.
Installation Precautions
The WSK-21-W Wall Switch Kit is tested and safe when
installed in accordance with this installation manual. It is
your responsibility to read all instructions before starting
installation and to follow these instructions carefully during
installation.
Do not install any components that may be damaged.
Do not modify, disassemble, or substitute any of the
components included with this kit. Installation of this kit
must be done by a qualified service technician.
The wall switch kit is carefully engineered and must be
installed only as specified. If you modify it or any of its
components, you will void the warranty and you may
possibly cause a fire hazard.
All wiring should be done by a qualified electrician and
shall be in compliance with local codes and with the
National Electric Code ANSI/NFGA No. 70- current (in the
United States), or with the current CSA C22.1 CANADIAN
ELECTRIC CODE (in Canada).
NOTICE: DO NOT connect 110-120 vac wiring to the gas
control valve of this appliance or to the wall switch for in-
stallation of this kit. Component damage will occur.
WSK-21-W WALL SWITCH KIT
- Installation And Operating Instructions -
Hearth & Home Technologies • WSK-21-W Instructions • 130-900 Rev. K • 1/20
WALL
SWITCH
PLATE
SCREWS
WIRE
CONNECTORS (2)
Figure 1.
Preparation
CAUTION! Risk of Burns! The fireplace should be
turned off and cooled before kit is installed.
Remove decorative barrier front if previously installed.
Installation instructions
Installing the Wall Switch
1. Install the wall switch in a convenient location. Run
low voltage, 2-conductor wire from the wall switch into the
base of the appliance.
2. Determine which ignition system is installed on the ap-
pliance using Figures 2, 3 and 4. Connect the 2-conductor
wire accordingly.
WALL
SWITCH
1