Page 1
OPERATION MANUAL Opti-Mist ™ Wide Area Sprayer...
Page 2
NSS Chemical Use Disclaimer WARNING: Chemical use hazard. Each chemical, such as a disinfectant, has a unique set of hazards and needs to be handled properly to ensure worker safety. Read and understand the chemical product’s SDS and label prior to use.
Do not use with acetone, undiluted acids or solvents. ALL REPAIR SERVICE MUST BE PERFORMED BY AN NSS AUTHORIZED DISTRIBUTOR / SERVICE STATION USING ONLY NSS ORIGINAL EQUIPMENT PARTS. SAVE THESE INSTRUCTIONS...
ALWAYS recharge the battery until the green LED on medical attention if the symptoms persist. the battery is lit. ALL REPAIR SERVICE MUST BE PERFORMED BY AN NSS AUTHORIZED DISTRIBUTOR / SERVICE STATION USING ONLY NSS ORIGINAL EQUIPMENT PARTS. SAVE THESE INSTRUCTIONS...
Page 5
Markings IMPORTANT SAFETY INSTRUCTIONS Below are descriptions of the various marking used on the WARNING: Read these original instructions prior to initial use of the Op[ti-Mist 20B: appliance/machine. #1 This product may contain a chemical known to the Safety Instructions: state of California to cause cancer, or birth defects or other reproductive harm Safety Equipment...
Page 6
FIGURE A GROUNDING OF ELECTRICAL EQUIPMENT - BATTERY CHARGER WARNING: Improper connection of the equipment–grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded.
Located in the far left side of the control panel is the Power Switch. The toggle switch is in the “OFF” The Opti-Mist 20B is intended for commercial use, for position when it is down and is in the “ON” position spraying of liquid solutions on level floors in an indoor when it is up.
Machine Operation Side Spray Bars - The Side Spray Bars are attached to the outboard ends of the Center spray bar with a swivel The machine is designed to enable a plurality of spraying attachment. The side spray bars can be turned off by closing options.
Battery Charging When the machine is supplied with batteries installed, the Always turn OFF all machine switches before battery charger is set by the NSS factory for the installed performing any maintenance. batteries. DANGER: Charge the batteries in a well ventilated area.
TROUBLESHOOTING Symptom Cause Solution No Solution From Spray Spray nozzle tips plugged. Disassemble and clean. Tips Solution tank empty. Refill tank. Pump failed. Repair or replace as required. Defective pump seal. Replace pump. Uneven Spray Nozzle Spray nozzle tips plugged. Clean or replace.
Page 11
GENERAL INFORMATION AND WARNINGS Flashing Red LED at start up indicates one of the • This NSS machine is are delivered with the two WET charging curves. SPE CBHD1 24-5 battery charger set for Flashing Green LED at start up indicates one of 35AH AGM batteries.
Need help?
Do you have a question about the Opti-Mist 20B and is the answer not in the manual?
Questions and answers