Advertisement
Quick Links
RS-096-MK6
Plenum-Rated Water Leak Detection /
HVAC & AC Condensate Pan Overflow Alarm
with Step-Down Transformer & Plenum-Rated Wires
Congratulations on your purchase of a FloodMaster RS-096-MK6 plenum-rated plumbing leak
detection and HVAC/AC condensate pan overflow alarm from Reliance Detection Technologies.
This product is designed to alert you if a leak or near overflow condition is detected.
To ensure proper installation and to maximize the performance of your RS-096-MK6 water leak
detection system, please read this manual thoroughly before installing or operating the system.
NOTE: This installation and operating manual contains important information about the operation of the
RS-096-MK6 system. If this system is being installed for use by a different user, please be sure a copy of
this manual is left with the system for future reference.
Warning: For indoor use only.
www.RelianceDetection.com
Toll-Free: 888-771-4929
RS-096-MK6 System Components (included in kit):
1 – Receiver box
1 – Step-down transformer (120, 208, 240V AC
to 24V AC ) and mounting plate
1 – Water sensor with 8' lead wire
1 – Metal plate for sensor placement
Advertisement
Summary of Contents for RDT FloodMaster RS-096-MK6
- Page 1 HVAC & AC Condensate Pan Overflow Alarm with Step-Down Transformer & Plenum-Rated Wires Congratulations on your purchase of a FloodMaster RS-096-MK6 plenum-rated plumbing leak detection and HVAC/AC condensate pan overflow alarm from Reliance Detection Technologies. This product is designed to alert you if a leak or near overflow condition is detected.
- Page 2 INSTALLATION INSTRUCTIONS 1. Mount the receiver box in the desired location using supplied two-sided tape. 2. The receiver connector comes prewired with basic connections to the power supply and the sensor. Using an appropriate screwdriver, make any additional desired electrical connections for output contacts or additional sensors per Figure 1.
- Page 3 RS-096-MK6 1. Receiver box 5. Water sensor 2. Power LED 6. Metal plate WATER 3. Reset button 7. Step-down transformer 4. Wiring terminal block 8. Transformer mounting plate ALARM KIT mating slot FRONT VIEW SIDE VIEW 1.08 1.48 1.69 2.06 2.66 2.65 Ø...
- Page 4 TRANSFORMER MOUNTING INSTRUCTIONS The kit contains a cover plate for a standard junction box. The cover has a hole or knock out in the center of it. The cover plate is designed such that the transformer can be mounted to it and then screwed into the junction box.