Download Print this page

Omega Kidney Shaped Susan Manual page 2

Hide thumbs

page of 3

/ 3
Bookmarks

Step 3: Fasten the Top Mount to the cabinet top with all Four #8 x 1/2"

Truss Head Screws.

Step 4: Put the Decorative Caps on the top of the Pole-Susan Bear-

ings that are attached to the Wood Susans.

The next steps can be done inside the cabinet or outside the cabinet if

there is room to maneuver the complete assembly into the cabinet.

Step 5: Install a Wood Shelf Assembly, which includes a Wood

Shelf

Pole-Susan Bearing

ing it onto the

Pole Mount Bearing Assembly

the

ter Pole

above the holes and insert a

of the three holes in the

hole for the height desired)

Pole Mount Bearing Assembly

Step 6: Slide the

press on to the

Pole Mount Bearing Assembly

Pole Mount Assembly

as the Height Adjustment Screw. Note: The

Bearing Assembly

by removing the

Pole Mount Bearing Assembly

side of the

TIGHTLY

screwed down.

Repeat Steps 5&6, If you are installing a 3 Shelf Unit.

Step 7: Slide another Wood Shelf Assembly which includes a

Pole Susan Bearing

Center Pole

of the

cabinet, tilt the Pole and Susan Assembly and insert it into the

cabinet at this time.

Step 8: Slide the bottom of the

Bearing

lining up the notch in the

trusion in the

Pole

is seated all the way down).

Step 9: Holding the Center Pole down in position, slide the Extension

Pole into the Top Mount (make sure it is all the way in) and

tighten the Height Adjustment Screw on the Center Pole.

Step 10: Rotate all the Wood Susan Shelves until they detent. Rotate

the Center Pole until the Wood SusanShelves are in the de-

sired position, aligned with the front of the cabinet.

Step 11: Carefully lift the bottom shelf and add two additional #8 x 3/4"

Truss Head Screws in the Base Mount Support and make

sure all the screws are tight.

, and

Center Pole

from the bottom. Follow this with

Center Pole (choose the speciﬁc

Retaining Pin

by lining it up to the slot in the

. Tighten the screw on the

making sure it is on the same side

can be positioned at any random height

Retaining Pin

and using the screw on the

Decorative Cap

, and

. If the parts were assembled outside of the

Center Pole

Base Mount Bearing

Susan

Decorative Cap

, by slid-

Cen-

and slide it up the

Retaining Pin

in one

back down and

Pole Mount

. Make sure it is

Susan

, on to the bottom

Base Mount

into the

with the pro-

Center

(make sure the

Step 3

Step 4

Step 5

Step 6

Step 8

Step 9

Height Adjustment Screw

Screw

Form OME-006, 09/2004