Do you have a question about the 03077 and is the answer not in the manual?
Questions and answers
Summary of Contents for Atel Electronics 03077
Page 1
Contents Product Introduction Thanks for buying CO2/TEMP/RH DATA LOGGER. Product Introduction used It's for measuring CO2 concentration, Carbon temperature, dew point Grade Guide temperature and wet Dioxide humidity, bulb temperature. Button Function much CO2 indoor tired, not will easy cause concentration, even cause sick...
Page 2
Button Function Display Description: Power: on/off button. CO2 displaying zone: °C/°F data PPM: CO2 concentration displaying Up key: higher. The button toggles between celsius and Fahrenheit C02: Co2 displaying left key: When the main setting MON: Count unit of “Month” interface, turn on/off the CO2 concentration alarming.
Page 3
Features Specifications Super simultaneously display and large Large 3.5” Display: (8.9cm) with display Calendar Temperature, Relative Level, Humidity, backlight Time (clock) Logger mode: start/ stop, Immediately, data 12700 logging memory » Schedule, Real-time Roll-over & WARNING CARBON DIOXIDE LEVEL! Carbon Dioxide (CO2) Stable for CO2 concentration...
Page 4
Steps Using Software Installation: side connects Open power adapter, need open the disk, to install English First, electrical power, the other side connects this to the power please software, choose file: “HT2000X(setup)”, of product, then work. steps please see the below: When working outside no lectrical power, with...
Page 5
Software Use tthe you installed the software, please insert the interface, After instrument next operations please the diagram IrotllHT Commuricaton Tool fo soussel sryorie who uses comple Everons Odustge Communication Data View Help THRO: (Gare HIl6z Communication Tool “ After clicking the button of then please...
Page 6
need However, many times, we to go outside Param| wal: Set Time setParam Retresn Read {Dats Dogsnload stop Recording measure datas, connect is difficult to the PC, Lge ntent then, we can measure manually, after that we can take datas the received home and connect...
Page 7
The setting of parameter same as we've quite mentioned before, the only differences that need change the “instant measuring ” into’manual measuring ”. After finishing setting, we need to exit the software and unplug the wire. Take the instrument outside, at first please press connect...
Need help?
Do you have a question about the 03077 and is the answer not in the manual?
Questions and answers