Globus New Media ECO Spot PCE Series User Manual

ECO Spot™ PCE-Series User Manual
Thank you for choosing an ECO Spot™ Gobo Projector.
This manual covers our Patented ECO Spot PCE-Series models.
Please read this manual before installing or operating the fixture,
follow the safety precautions listed below, and observe all warnings.
Package Contents

Projector with power cord

Test Gobo

Spare gobo retaining ring

Mounting hardware for yoke
Safety Information
•
Please unpack and carefully check for damage caused during transportation.
•
Light fixtures should be installed and maintained only by qualified personnel
with experience in lighting equipment and general electrical experience.
•
When suspending the fixture above ground level, verify that the structure can
hold at least 10 times the weight of all installed devices.
•
Verify that all external covers and rigging hardware are securely fastened and
use an approved means of secondary attachment such as a safety cable.
•
Place your fixture at a suitable place with good air flow.
•
Keep flammable materials away from the fixture.
•
Minimum distance to flammable material = 1 ft. (0.3m).
•
Provide a minimum clearance of 4 in. (10cm) around air vents.
•
Use only genuine spare parts for part replacement.
•
Do not look directly into the lamp; it can result in eye damage.
•
Always unplug the unit from the power mains before any service is done.
Electrical Safety
•
Disconnect the fixture from AC power before handling it.
•
Always ground (earth) the fixture electrically.
•
Use only a power source that complies with local building and electrical codes
and has both overload and ground-fault protection.
•
Do not use the fixture if the power cable or power plug is in any way damaged
or defective, or if they show signs of overheating.
Copyright © 2019 Globus New Media LLC
ECO Spot PCE-Series User Manual
Page 1