Advertisement
9889 Garrymore Ln
Missoula, MT 59808
888-687-3552 | +1-406-549-0769
www.aquacreek.com
Check entire box and all packing materials for parts. Before beginning assembly, read the
instructions and identify parts using the figures and parts listed in this document.
It is critical that all parts be carefully inspected prior to installation. If any damage occurred in
transit, Aqua Creek Products, LLC must be notified within three days of receipt of unit.
Proper installation cannot be overstressed, as an improper installation voids Aqua Creek's
warranty and may affect the safety of the user.
Copyright © 2016 Aqua Creek Products All Rights Reserved
Revolution Gurney
350 POUNDS - STANDARD REVOLUTION
300 POUNDS - DEEP DRAFT REVOLUTION
Lift safety can only be ensured if the lift is installed and
operated according to these instructions.
• NEVER permit children to play on or around the lift
• Do not allow children to use the lift without adult
supervision
• NEVER apply direct water pressure to the electronics
• NEVER use the lift with a dry pool
READ CAREFULLY
Attachment
PART #: F-730RSA-S2
WEIGHT CAPACITY:
MANDATORY
LEAVE THIS MANUAL WITH LIFT OWNER
Read and follow all instructions.
1
Revised 12/13/16
Advertisement
Table of Contents
Related Manuals for Aqua Creek Products Revolution F-730RSA-S2
Summary of Contents for Aqua Creek Products Revolution F-730RSA-S2
- Page 1 It is critical that all parts be carefully inspected prior to installation. If any damage occurred in transit, Aqua Creek Products, LLC must be notified within three days of receipt of unit. Proper installation cannot be overstressed, as an improper installation voids Aqua Creek’s warranty and may affect the safety of the user. Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16...
- Page 2 1/4" X 3-1/2" BUTTON-HEAD CAP-SCREW (2) ALIGNMENT BLOCK 1/4" FLAT SAFETY EXTENSION WASHER (2) STRAP TUBE 1/4" NYLOCK NUT (2) 1/4" FLAT WASHER 1/4" X 1/2" BUTTON HEAD CAP SCREW Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16...
- Page 3 Loop safety clips around back of attachment tube and clip over safety pins to keep pins from slipping out of the holes. CHAIR ARM ALIGN W/TOP HOLE SAFETY PINS Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16...
- Page 4 THE ARMS FIT BETWEEN MIDDLE LEGS OF THE GURNEY. LEGS ARMS FIGURE 1 LOWER ATTACHMENT UNTIL IT FITS UNDER THE GURNEY-BED ROLL GURNEY OVER ATTACHMENT WRAP SAFETY STRAPS OVER GURNEY (2) FIGURE 2 Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16...
- Page 5 GURNEY FITS ON THE ATTACHMENT AS SHOWN - BETWEEN THE ALIGNMENT BLOCKS. ALIGNMENT BLOCKS FIGURE 3 ALIGNMENT BLOCKS (EACH SIDE AND ENDS) SAFETY STRAP (2) TO HOLD DOWN FIGURE 4 EACH END Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16...
- Page 6 2. Store the gurney and gurney attachment in a dry location, away from pool chemicals. Do not store these items outdoors or in direct sunlight. 3. Inspect the attachment and the safety clips for rust or damage. Clean/replace as necessary. Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16...
- Page 7 NUT, 316 SS, NYLOCK, 1/4”-20 SNAP PIN 5/16 X 4 1/2” SS SNAP PIN 5/16” X 4 1/2” USABLE LENGTH RER-1X2-10-14 CAP, PLASTIC, RECTANGLE, 1”X2”X.120” WALL SQR-1-1/2-10-14 CAP, PLASTIC, 1.5” SQUARE, .134-.083 WALL Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16...
- Page 8 NO EVENT SHALL AQUA CREEK’S LIABILITY EXCEED THE ENTIRE AMOUNT PAID TO AQUA CREEK BY THE ORIGINAL PURCHASER FOR THE FAILED OR DEFECTIVE PRODUCT. IN NO EVENT SHALL AQUA CREEK PRODUCTS, LLC BE LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL, SPECIAL, INDIRECT, PUNITIVE OR EXEMPLARY DAMAGES OR LOST PROFITS FROM ANY BREACH OF THIS LIMITED WARRANTY OR OTHERWISE.
Need help?
Do you have a question about the Revolution F-730RSA-S2 and is the answer not in the manual?
Questions and answers