Jazwares 10109 User Manual

Please read the instructions along with the selfie stick carefully
before use, so that you can operate them correctly.
Congratulations on your purchase of the Selfie Stick!
To get the most out of your Selfie Stick please read this manual
as it will help you explain to proper usage.

SAFETY TIPS:

• Use this only as intended.
• To prevent fire or shock hazard, do not expose this unit
to rain or moisture.
• Do not submerge the unit in any liquid
• Do not disassemble

Battery Information:

Warning:
• Batteries are to be replaced by an adult.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged
• Rechargeable batteries are only to be charged under adult supervision.
• For best performance only the recommended batteries or their equivalent are
to be used.
• Batteries must be inserted with correct polarity.
• Do not mix new and used batteries.
• Do not mix different types of batteries.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not immerse in water. Sponge clean only

Using Your Selfie Stick:

STEP 1:
Press and hold the button for
3 seconds. A blue light will appear,
indicating that the selfie stick has been
powered on
STEP 2:
When the blue light begins to flicker, the selfie stick is
ready to pair with your bluetooth enabled device.
STEP 3:
Rotate the mobile clip for 270
View of Combo degrees follow the arrow.
Rotate the mobile clip for 270
degrees and then hold the two sides
of the monopod to stretch slowly
step by step.
ITEM # 10109 - Selfie Stick
Included in box:
• Selfie Stick : Tripod
• User Guide and Warranty
Long press the button for 3 seconds
after the start of the Bluetooth pairing mode
View of stretch of
monopod
USER GUIDE
© Jazwares, LLC. 2016
Using Your Selfie Stick (cont.):
STEP 4:
Put the mobile to the clip and open
the camera function on mobile
to take picture by pressing the camera
button on monopod.
Tips :
1. If you do not use the monopod to take a picture while the bluetooth
devices connect successfully for 5-10 minutes, the monopod will
turn to sleep mode and the light of camera button will also turn off.
Just shortly press the camera button to restart the function.
2. If the distance between the mobile and monopod is over 10 m,
the monopod will also change to sleep mode.
Please keep the 2 devices within 10 m.
STEP 5:
Extension holder
Draw back the mobile clip
for 270 degrees and follow
the arrow
Rotate the mobile back and hold the bottom of the extension holder,
press it with your thumb.
Make the other side of the holder up to the hard part then draw it back slowly.
LED:
LED 3
LED 2
LED 1 Charge Indicator
Whe unit is charging, LED 1 will be red color. It will be white wheen charge is complete.
LED 2 Bluetooth Matching
When the light is white and blinking, the unit is in bluetooth matching mode.
LED 3 Photograph Indication Light
The light will be blue while taking photos.
NOTE:
Maximum bearing capacity at the joint between the intergrated camera assistant
phone stand and the hardware rod is 5kg
Go to
TubeHeroesUniversity.com/products
for a complete tutorial.
Also Visit www.tubeheroes.com
Need More Help?
Do Not Return Item to Store.
Call 1-800-370-1827 and speak to a customer service representative.
Mobile clip (The size of mobile from 55MM-90MM)
Extension holder
Remote holder
View of combo
LED 1
Ages
8+