Table of Contents
Advertisement
Operation (continued)
LIGHTING
CAUTION:
3. Control knob must be in the "OFF" position (Figure 2).
4. Clear small area of glass rocks away from the igniter cover (Figure 3), make sure no glass rock between thermocouple and burner.
5. Connect the LP gas tank per "Assembling the LP Gas Tank" section.
6. Wearing heat-resistant gloves, position a long lit match or long lit butane lighter near the burner.
7. Turn the control knob to HIGH.
9. Remove match/ lighter once the burner is lit.
10. If ignition does not occur in 5 seconds, turn the burner control knob to OFF, wait 5 minutes, fan with a newspaper or magazine, and repeat
the lighting procedure.
CAUTION:
CAUTION: If ignition does not occur in 5 seconds, turn the control knob to "OFF", wait 5 minutes, fan with a newspaper or
magazine, and repeat lighting procedure.
Igniter cover
TURNING OFF
1. Turn the control knob to the "OFF" position.
Note: A "poof" sound is normal as the last of the LP gas is burned.
2. Disconnect the LP gas tank per "Disconnecting LP Gas Tank" section.
Figure 3
10
tube can lead
.
4 in. - 6 in.
10 -15 cm
Figure 4
Advertisement
Table of Contents
