Kathrein UWS 24 Manual

UWS 24 20550001
Wideband to Quatro Converter

About this Manual

This document is part of the product.
► Read this manual carefully before using the converter
for the fi rst time.
► Keep this document for reference throughout the
service life of the device and pass it on to any new
owner or user.
For the most up-to-date version of this manual, go to
www.kathrein-ds.com.
Keep this manual in a safe place for future
reference and include it with the unit when
passing it on to the next user.

Features

■ Converter for converting two wideband signals to four SAT-IF levels
■ The use of terminating resistor EMK 03 (order no. 237169) enables the adaptation to the LNB's oscillator frequency
(10.40 GHz or 10.41 GHz)
Power supply via "horizontal low" trunk
■
■ Terrestrial signals in the 5–862 MHz band can be received even when the satellite receiver is switched o
■ Installation on EXR 2508 (order no. 20510095) or EXR 2558 (order no. 20510096) possible using EMU 250 coupler
(order no. 20510044)
■ Kathrein Power Saving:
If no receiver is active in a system using Kathrein Power Saving, both the LNB and the converter are switched o

Scope of Supply

■ UWS 24
● Instructions for use for UWS 24

Transport and Storage

► Use the original packaging for transporting the device; store it in a dry place
► Make sure there is no water condensation build-up.

Intended Use

► The device described in this manual is only intended for the installation of satellite reception systems and may only
be installed by trained specialists
► Any other use or the non-observance of these instructions will result in the loss of the warranty and guarantee
► The manufacturer accepts no liability for accidents caused by the user opening the unit
► Opening the unit and attempting to repair it yourself voids all warranty claims
suitable for DVB-T/T2
44,1
1 / 4
V high
Digital Systems GmbH
V Wideband H high
UWS 24
Terr.
H Wideband H low
18 V 18 V
Config V low
205500001
63,45
111,5