Advertisement
Customize Your Network Security
When you first set up your network, the setup uses a default
encryption key common to all adapters. You can change this.
¾ To create a private secure network:
1. Wait until the Pick A Plug LEDs are lit.
2. Press the Security button for two seconds on one adapter, and
then press the Security button on one of the other adapters
for two seconds. Both buttons must be pressed within two
minutes.
Note:
The Security button does not work in power saving mode
(see
Troubleshooting Tips
Warning: Do not press the Security button on the PowerLINE
adapter until installation is complete and the adapters are
communicating with each other (indicated by the Power LED).
Pressing this button too soon can temporarily disable PowerLINE
communication. If this occurs, use the Factory Reset button to
return the PowerLINE adapter to its factory default settings.
If you add adapters later, use this procedure to add the new
adapters to your secure network.
on page 13).
12
Advertisement
