Connecting The 230 V Power Source (Mains Priority Circuit) In A Caravan/Recreational Vehicle; Connecting To The Bluetooth® Remote Control Module - AEG SW 600 W Manual

Connecting the 230 V power source (mains prior-
ity circuit) in a caravan/recreational vehicle
Only applies to SW 1500 W, SW 2000 W, SW 3000 W
Danger!
The connection must be made by a qualified electri-
cian. An incorrect connection can cause life-threat-
ening situations for you and others and damage
the vehicle and connected devices. It may void the
warranty of the manufacturers.
Prerequisite:
•
caravan with CEE supply socket
•
blue CEE plug to connect to the power distribu-
tion
•
maximum distance of 20 m to the power distribu-
tion (corresponds to a maximum cable length of
25 m)
Starting situation:
230 V sockets inside the caravan/recreational
vehicle are supplied by the caravan's CEE supply
socket.
1. Disconnect all consumers from the 230 V sockets
in the caravan/recreational vehicle.
2. Disconnect the CEE supply socket from the
mains.
3. Expose the line from the CEE supply socket to
the 230 V sockets in the desired location of the
caravan/recreational vehicle. Please note the
information under "Installation" with respect to
the location of the voltage converter.
4. Disconnect the existing cable link between the
CEE supply socket and the 230 V sockets in the
caravan/recreational vehicle.
230 V sockets in caravan/recreational vehicle
CEE supply
socket
5. Install the respective low heat device socket at
the open cable end (coming from the CEE supply
socket).
6. Install the respective low heat device plug at the
open cable end (coming from the 230 V sockets
in the caravan/recreational vehicle).
7. Connect the installed connections to the 230 V
input [6] and the 230 V output [5] on the voltage
converter.
230 V sockets in caravan/recreational vehicle
Connecting to the Bluetooth® remote control
module
Caution! Risk of damage
Only applies to SW 600 W or SW 1000 W
If you purchased the Bluetooth® remote control
module as an accessory, connect the connect-
ing cable [15] to the socket [2] on the front of the
voltage converter. Connection via the socket on
the back [8] may damage the device or the remote
control module.
1. Insert one plug of the connection cable [15]
into the connection socket [2] on the voltage
converter.
2. Plug the other connector of the connecting
cable [15] into the port at the back of the remote
control module. The voltage converter can now
be operated via the remote control module.
Power
distribution
English 35
CEE supply Power
socket distribution