Connecting Speakers - Yamaha RX-V590 Owner's Manual

CONNECTING SPEAKERS

Connect the respective speakers to this unit as figured below.
Center speaker
Note on front speaker connection:
One or two speaker systems can be connected to this unit. If
you connect only one speaker system, connect it to either the
SPEAKERS A or B terminals.
Note on center speaker connection:
One or two center speakers can be connected to this unit. If
you cannot place the center speaker on or under the TV, it is
recommended to use two center speakers and place them on
both sides of the TV to orient the center sound at the center
position.
For connecting two center speakers, follow the method shown
below.
REAR
CENTER
Center speaker
8
Rear speakers
Right
8 MIN.
/SPEAKER
REAR
CENTER
C D:4 MIN./SPEAKER
SINGLE:8 MIN./SPEAKER
A
B
Right
Front speakers B
C D
DUAL
SINGLE
Center speaker
Left
OUTPUT
FRONT CENTER REAR
C D
DUAL
LOW
PASS
SINGLE
fc:200Hz
SPEAKERS
SPEAKERS
A
B
FRONT
Left
IMPEDANCE SELECTOR switch
(Canada model only)
Be sure to switch this only when the power of this unit is
turned off. Select the position proper for the use of your front
speakers.
A OR B:USE 4 MIN.
/SPEAKER
A B:USE 8 MIN.
/SPEAKER
A OR B:USE 8 MIN.
/SPEAKER
IMPEDANCE
SELECTOR
SELECTEUR
D'IMPEDANCE
FRONT LEVEL switch
(Australia model only)
Normally set to "0 dB". If desired, you can decrease the
output level at the FRONT SPEAKERS terminals by 10 dB by
setting this switch to "–10 dB".
Right Left
Front speakers A
When using one pair of front
speakers;
•
If the impedance of each speaker is
8Ω or higher, set to right (
•
If the impedance of each
speaker is 4Ω or higher, but lower
than 8Ω, set to left (
When using two pairs of front
speakers;
The impedance of each speaker must
be 8Ω or higher.
Set this switch to left (
l0 dB 0 dB
FRONT
LEVEL
).
).
).