Table of Contents
Advertisement
Available languages
Available languages
First steps
The tubing comes in one piece. Please cut it into suitable pieces.
1.
Plan which areas are to be irrigated. Measure the sections of the tube.
2.
Cut the hose (f.e. with large scissors) in the place you want the spray nozzles to be.
Bear in mind that there will be a maximum of nine tubing sections.
3.
Put the tubing sections over the plug nipples of the nozzle connectors. To ease con-
necting tubing to fittings, briefly hold the corresponding tubing end in hot water
before connecting.
4.
Put the end plug to the end of the last tubing section.
Setup
1.
Screw the faucet connector (A) to the faucet.
2.
Pull the first tubing section (B) over the plug nipple of the quick release connector.
3.
Put the quick release connector with the tubing section until it is locked with a click-
ing sound.
4.
Arrange the assembled irrigation system along the area to be irrigated.
5.
Use the nail clasps and loop clips to fix the tubing.
6.
Turn on the faucet and observe the functioning of the irrigation system. Check if all
connections are assembled correctly and there is no leakage.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin. Germany
8
Installation
Advertisement
Table of Contents
