Connections - Yamaha GX-700 Owner's Manual

Connections

Never plug the AC supply lead of this system into the AC outlet until all connections are completed.
Subwoofer system
(Separate purchase)
INPUT
Front speakers
L R
Connecting speakers
Connect the speakers to the corresponding speaker terminals on the rear of the main unit respectively by using the speaker cords.
Make sure that the polarity of the speaker cords is correct, that is the + and – markings are observed. If these cords are reversed,
the sound will be unnatural and lack bass.
On the speakers
Red: positive (+)
Black: negative (–)
2
1 3
Caution
Do not let the bare speaker wires touch each other as this could damage the amplifier and/or speakers.
When connecting a subwoofer (separate purchase)
You may wish to add a subwoofer to reinforce the bass frequencies.
When connecting a subwoofer to this system, connect the SUBWOOFER OUT terminal of this system to the INPUT terminal of the
subwoofer.
* Ordinary subwoofers, including the Yamaha Active Servo Processing Subwoofer System, are designed so that the amplifier and
subwoofer are in the same unit.
* The SUBWOOFER OUT terminal outputs low frequencies from the left front, center and right front channels.
(The cut-off frequency of this terminal is 200 Hz.)
Rear speaker
Center speaker
R
REAR
SUBWOOFER
VIDEO SIGNAL
OUT
MONITOR
OUT
R L
OUT
CENTER: 6
VCR REAR:
IN
VIDEO
OUT
AUX/MD
IN
6
1 Press the tab
2 Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
3 Release the tab and
secure the wire.
Preparations and connections
Rear speaker
SPEAKERS
SEE OWNER'S MANUAL
FOR CONNECTION.
R CENTER L REAR
MIN./SPEAKER
I2 MIN./SPEAKER
FRONT
R L
MIN./SPEAKER
SPEAKERS
On the main unit
Red: positive (+)
Black: negative (–)
1
3
2
L
MAINS
To AC outlet
1 Press up the tab.
2 Insert the bare wire.
[Remove approx. 5mm (1/4")
insulation from the speaker
wires.]
3 Press down the tab and
secure the wire.
E-7