By cleaning and servicing your appliance regularly and expertly you will ensure a long-lasting functioning over many years� RIKA is always ambitious to provide an excellent service� Have a good time, enjoying the cosy warmth of your RIKA stove as often as you wish� RIKA Innovative Ofentechnik GmbH 2.
Your stove is equipped with a state-of-the-art control system� You Standard functions can control all functions on the touch display� The surface of the touch display responds to both finger pressure and touch pen� Each stove model provides the following standard functions:...
Opening the ROOM SENSOR decorative glass door only with RIKA room sensor / RIKA radio room sensor ECO function In addition to the standard functions, the combi stoves dispose of an only with RIKA GSM Control ECO function�...
STOVE OFF it is not possible to start up the stove� Comfort mode Note The comfort mode may only be selected if a RIKA room sensor is connected� During the heating times, as saved, your stove keeps a nominal room temperature preset by you�...
Attention: Electrical voltage - disconnect the power plug before working on the device! Only use a 230 V lamp from the original RIKA spare parts range� (1 lamp included in the delivery�) When 12 V / 24 V lamps are used, there is a risk of explosion of the...
Classic, Info and Dark� Classic: RIKA sustainability-themed screensaver Info: Actual and nominal temperature or heat output (depending on mode, only possible with RIKA room sensor connected) Dark: a darkened screen In the Advanced menu, you can set the delay time in minutes (1 - 60 min) and the brightness�...
Discharge motor current Disconnect the main plug for a short time� When the display shows the RIKA Logo on orange screen, there is the name of your stove Actual current consumption (0 - 120) in the left corner� Touch the stove name, and the software version Flue gas fan [1/s] actually installed will be displayed�...
7. EXTENDED OPERATING MODES - PELLETS / LOGS (only combi stoves) Your combi stove features an automatic fuel recognition and a The RIKA firelighter no� E15834 is available from your RIKA dealer� combustion regulation� Operation may any time switch between pellets and logs�...
Combined operation Log operation in case of power breakdown Automatic ignition of firewood during start-up, or automatic log Note recognition during operation� Your stove must be disconnected from the mains for current-free Automatic ignition of firewood during start-up operation� Place two logs into the firebox� Be sure that at least one of the logs lays above the combustion trough to facilitate burning�...
8. NOTES AND WARNINGS To ensure trouble-free functioning, your stove is equipped with a number of safety devices� Notes Bake time until Bake time until Big clean Big clean 2:45 H 0:28 H Note Bake + 2h Bake Clean before Clean before Each time you switch to the baking mode, the remaining time Each time you switch to the baking mode, the remaining time...
Warnings Burn back and Burn back or Position switch Flue Gas Flap open flue gas flap open open Warning Please Close Please close Please close Burn-back flap and flue gas flap are not Burn-back flap and flue gas flap are not Meaning Der Ofen ist nicht in Betriebsposition�...
9. ERROR MESSAGES If an error occurred, your stove switches over to the operating state BURN-OFF� After the appropriate measure has been taken, acknowledge the error message� Your stove will be ready for use again� Note If the error messages appear again and again, please contact the customer service without delay� Meaning Error Text...
Page 15
The firebox door and/or the pellet hopper lid are open� Firebox door and/or Pellet container lid open Close the firebox door and/or the pellet hopper lid and acknowledge the error message� Touchscreen is distorted� No further entry is possible� Touch display blocked Please inform customer service�...
The air flaps are not in correct position� Air flaps Motor fault Acknowledge the error message� The room temperature has exceeded 30°C� Room sensor Room overheated Allow the room to cool down� You can only cancel the error at a room temperature of less than 30°C�...
Air flap Fault The air flaps cannot be activated correctly� Communication Mainboard The connection from the mainboard to the touch display has Fault been lost� Communication The connection from the mainboard to the (radio) room sensor has been lost� The stove switches to burn-off after one hour�...
Pressure sensor The pressure sensor can not achieve the minimal set pressure�� Pressure sensor Timeout Check the stove for tightness (firebox door, cleaning lid), for disturbing factors in the installation room (kitchen hood, windows closed,���), as well as the flue� The connection to the pressure sensor has been lost�...
Need help?
Do you have a question about the Touch Display and is the answer not in the manual?
Questions and answers