Eagle Health Supplies 55232 Instruction Pamphlet

1.
Take one leg frame (Part B or Part C,
it does not matter which), and lay it
flat on the ground.
3.
Take the other leg frame (Part B or
Part C), and insert the seat tubes on
the opposite side of the seat (Part A)
into the leg frame. Make sure the
brass
buttons
snap firmly
into the
leg frame.
5.
Take the backrest (Part E), and
insert it into the two oblong
backrest holes located on top of
the seat towards the back side of
the seat. Push
the backrest
down into the
backrest holes,
snapping it
firmly into
place.
2.
Take the seat with the two
pre-assembled tubes located
under the seat
(Part A), and
insert the two
tubes into the leg
frame (Part B
or C). Make sure
the brass buttons
snap firmly into
the leg frame.
4.
Take the 4 legs (Part D), and insert
them into the bottom of the leg
frames. Set the chair height by
using the same button-hole location
for each leg. Make sure the brass
buttons snap firmly into the leg
frame. For
your safety,
adjust the
Rubber Tips on
the legs by
turning them
so they make
maximum
floor contact.
6.
Take armrests (Part F), and remove
the washers and fasteners. Insert
the armrests into the small round
holes at the left and right edges of
the top of the seat. Make sure
Armrests are positioned so they
flare out from
the seat. Place a
washer and then
a fastener on
each armrest
bolt underneath
the seat, and
tighten the
fastener until
securely
fastened.