Summary of Contents for Poniie PN-H20
- Page 1 User Manual Model No: PN-H20 Thank you for purchasing the Digital Heat Gun by Poniie. Please read this manual carefully before using this product.
- Page 2 High temperature industrial jobs are done faster with this heat gun, because our PN-H20 model has higher power rating and digital control function. Power rating goes up to 1800 watts (120 volts) and temperature goes up to 1300 ℉...
- Page 3 ○ Know your work environment. Remember that areas behind soffit board, ceilings, and floors may contain highly flammable materials. Check these areas before applying heat. ○ Be aware that heat can be conducted to hidden covered materials and may ignite them. ○...
- Page 4 placing the heat gun aside. ○ Do not keep the nozzle touching any surface while running or shortly after running. Avoid poking anything down inside the nozzle. ○ Do not touch the hot nozzle and wear safety gloves at any time. Please wear safety goggles at all times.
- Page 5 1 Four Nozzle Attachments 2 Built-in Over Heat Protection 3 High Quality Titanium Heater 4 Hands Free Built-in Stand Design 5 Digital Temperature Control 6 Auto Delay Off Protection Function Applicable power supply 110-125V 60Hz Maximum power 1800W(@120V) Temperature adjust step 10℉...
- Page 6 □ . Switching on and off 1.1 To switch the tool on, set the ON/OFF switch to position “I / II”. Note: Slight smoke may appear after switching on the gun for the first time, this does not indicate any problem. After a few minutes, it will auto disappear.
- Page 7 technique. For this reason, we have provided temperature guidelines for certain applications. Always start the heat gun at the lowest temperature in the range then raise the temperature until the optimum temperature is achieved. Always keep the heat gun in motion and at least 2" from the substrate when applying heat.
- Page 8 Do not use the heat gun on insulating laminated window glass such as Thermopane. The glass edge expansion may break the edge seal. When scraping fascia, do not overheat the edges of the asphalt shingles protruding over the edge of the sheathing. Too much heat will melt the asphalt. Maintenance Your Power Tool has been designed to operate over a long period of time with a minimum of maintenance.
Need help?
Do you have a question about the PN-H20 and is the answer not in the manual?
Questions and answers