Yamaha REV500 Operation Manual page 16

REVERB + CHORUS
This effect type, the source sound is processed separately by both the reverb and a chorus effect. The results
of this parallel processing are then mixed for output.
Note that in this effect type, the LPF and HPF (see COMMON parameters, above) are applied immediately
before the PRE DELAY. Hence, these filters do not affect the sound processed by the chorus effect.
Parameter
SPEED
DEPTH
MIX
REVERB ➔ CHORUS, FLANGER or SYMPHONIC
In these effect types, the output from the reverb is fed into a chorus, flanger, or symphonic effect.
Parameter
SPEED
DEPTH
FB LVL
MIX
12
Ctrl. No. Range
74 0.05 — 10.00 [Hz]
75 0 — 100 [%]
77 0 — 100 [%]
Ctrl. No. Range
74 0.05 — 10.00 [Hz]
75 0 — 100 [%]
76 0 — 100 [%]
77 0 — 100 [%]
Description
Modulation frequency
Modulation depth
Cutoff frequency of low pass filter
Description
Modulation frequency
Modulation depth
Feedback level (REVERB ➔ FLANGER effects only)
Cutoff frequency of low pass filter