Table of Contents
Advertisement
●
To taper hair down to the neckline, use closer cutting
attachment combs. Comb hair and check for uneven spots
and outline sideburns and neckline.(Fig.9)
If a short-tapered cut on the sides and back is desired,
follow the diagram below:
The four basic areas illustrated on the hair cutting guide are your "road map" to
easy do-it-yourself hair cutting.
●
Your clippers were carefully examined to ensure that the blades
were oiled and aligned before leaving our factory.
●
Blades must be realigned if they have been removed for cleaning or
replacement.
●
To realign the blades, simply match the upper and
bottom blades teeth up, point for point.
●
(End of top blade teeth) should be approximately
1.2mm back from bottom blade.
●
Compare your clipper blades with the sketch)
●
If blade alignment is incorrect, add a few drops of oil to
the blades, turn clipper on for a few moments, turn off and
unplug. Loosen screws slightly and adjust. Tighten screws
after blade is aligned.
●
To maintain your clipper in peak condition, the blades
should be oiled every few haircuts.
●
Do not use hair oil, grease, oil mixed with kerosene or
any solvent. As the solvent will evaporate and leave the thick
oil which may slow down the blades motion.
●
The lever is conveniently located near your thumb (if you're right
handed) so it can easily be adjusted while the clipper is in your hand.
●
The lever adds versatility to your clipper by allowing you to gradually
change the closeness of your cut without an attachment comb.
MAINTENANCE
OIL
ADJUSTABLE LEVER
12
Advertisement
Table of Contents
