BELLAGIO Cast Aluminium Lounger 881.42.001.16 Assembly Instructions

CAUTION:
1. Please read these instructions carefully before assembling. Count and organize all parts before you begin.
2. Assemble product on clean soft surface, such as a piece of carpet, so as to prevent the surface paint of parts from
scratching off.
PARTS&HARDWARE LIST
No. DESCRIPTION
A
B
C
D ARM (LEFT&RIGHT)
E LEVER BACK
F LINKING STRIP OF TYRE
G
H M8 HEADLESS
SCREWS
I CAP NUT M10
Bolt Cap M8
J M8×55 FLAT HEAD SCREWS
K M8×45 FLAT HEAD SCREWS
L COPPER RINGER
M M8 WASHER
N BIG WASHER M10*25
O M8 NUTS
P FEET PADS
Q SPRING WASHER
R SPANNER
ASSEMBLY：
1. Connect seat (A) to the left or right arms (D) with (H, M, Q, O).
2. Fix legs(C) to seat with (H, M, Q, O).
3. Install (L) the ends of the (F),then slip(G)on and fixed with (N,I).Connect left or right arms(D),linking strip or
type with(F,L,N,I).
4. Adjust the installed deck chair to even, that is to adjust the legs, arms to the same place, then tighten the screws.
5. Connect back (B) and (E) with (M, Q, I), do not over tighten.
6. Connect back (B) to the left or right arms (D) with (K, M).
7. Connect (E) and (B) with (J, M, P), do not over tighten.
8. Put the bolt cap (I) onto the M8 NUTS and BIG WASHER M10.
9. If (F) is on the adjustment file, please adjust it by (J).
10. If not even, adjust feet pad (P)
(Aluminum is soft metal, over tightening may strip thread or break parts)

ASSEMBLY INSTRUCTION

SEAT
BACK
LEGS
TYRES
M8*45
M8*50
M8*32
Over tightening can damage aluminum parts
PLEASE DO NOT OVER TIGHTEN
QTY
1
1
2
2
1
1
2
2
2
4
2
10
2
2
2
10
2
10
4
10
2