Mounting The Main/Rear Speakers (And Rear Center Speaker For Ns-P436) By Using Commercially Available Speaker Stands Or Brackets - Yamaha NS-P430 Owner's Manual

Mounting the main/rear speakers (and rear center speaker for
NS-P436) by using commercially available speaker stands or
brackets
You can also use the screw holes on the bottom of the
speaker for installing the speakers on commericially
available speaker stands (if you do not use the
attached mounting brackets.)
60 mm
Removing the front cover
Main/rear/rear center (for NS-P436)
Center
6
E-
A screw with a diameter of 4 mm
can be used.
(Hole depth : 10 mm)
Using the Yamaha Speaker Stand SPS-10MM (option)
By using the Yamaha Speaker Stand
SPS-10MM, speakers can be placed
on the floor. (Two stands make a set.)
SPS-10MM
* The SPS-10MM is not available in some areas.
The front cover is fastened to the enclosure at four points
and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the
speaker. To reattach, line up the four holes on the inner
surface of the cover with the four corresponding pegs on the
speaker and push gently.
Note
When the cover is removed, be sure not to touch the
speaker units with your hands or to exert excessive
force with tools.