5 .5 .1 . Turn the spreader onto its wheels and slide the handle assembly (42) around the frame, secure with 4 M6x40 hex bolts (24) and lock
nuts (25) .
5.6.
Refer to fig.8 for control lever and cable fitting.
5 .6 .1 . Insert the bent end of the control cable (38) into the small hole in the lever assembly .
5 .6 .2 . Remove the hex screws (17) from the cable clamp, then insert the control cable into the clamp (A,B) .
5 .6 .3 . Re-insert hex screws to clamp control cable in place .
5 .6 .4 . Move the flow control lever (C) down to open the spreader slot in the bottom of the hopper . If the hole (fig .13) is not fully exposed or fully
closed, loosen the cable clamp (B) and adjust the cable .
5 .6 .5 . Insert R-pin (12) through top of the vertical axle .
(51)
(54)
(55)
5.7.
Refer to fig.9 for fitting front and side deflectors.
5 .7 .1 . offer the 4-M6 X 30 screws (60) from inside the hopper and fit 4 brackets (57) to underside of hopper with spacers (9) between .
5 .7 .2 . Slide the boom rail (54) through the 1st clip in items (57) and (60), then brackets (57), finally the 2nd clip as indicated .
5 .7 .3 . Clamp all 3 deflectors with wing nuts (51) and carriage bolts (52) .