RF Elements StationBox Mikro Quick Installation Manual

Quick Installation Guide StationBox® Mikro
www.rfelements.com
1 How To Open StationBox® Mikro
STEP 1 Open the Bottom Cover
Release the lock. Lock is released.
Release the lock using thumb, check if the lock stays in released position.
STEP 2 Release the Base panel
How it works?
To perfom this step, both side-locks
of Auto-Lock system should be
released prior to pulling the Base
Panel out of the Top Cover.
There are two tricks how to do it:
Lock is locked. Release one side.
Slightly release one side of the bottom cover, then another side. Remove the cover.
A. Left-Right Way
Press the lock on one side of the box
and slightly pull out the Base Panel so
the lock does not lock again and stays
unlocked even when you release your
hand. Press the lock on the another
side and pull the Base panel out
completely.
Release one side-lock.
B. „Aloha" :) Way
You can do the same in one step using
only one hand. This is very useful
when outdoor, on the roof, ladder etc.
Grip the base panel with middle three
fingers of your hand. While pushing
the thumb and pinky to release both
side locks, pull out the Base Panel.
Grip the Base Panel.
Release another side. Release the bottom cover.
Good grip is very helpful - dry hands will
make the operation way easier.
Release another side-lock. Pull out the Base Panel.
Push. Pull out the Base Panel.
Make sure you say
Practice – soon, you will be able to do
the trick in a second.
®
„Aloha" :)