Advertisement
3. Thread webbing through hardware
Thread the webbing as shown (Fig. 6). Threading the webbing may be easier with the Band-It removed.
Locate the ideal placement of Dual Tab Tri-End on the footplate and adjust webbing length so the Dual
Tab Tri-End lays flat. Determine the proximity of the Dual Tab Tri-Ends to the client's foot; mounting it
closer to the foot will decrease the range of motion allowed at the ankle (Fig. 7).
4. Attach Dual Tab Tri-Ends
Mark the screw placement on the footplates. Remove footplates, if possible, and drill holes as marked,
using Dual Tab Tri-Ends as your drill guide. Make final tension adjustments and drill 16/20 in. screws
through Dual Tab Tri-Ends. For best results, anchor each screw with a nut and washer.
Note: Check manufacturer's warranty before drilling.
5. Trim webbing
Trim loose webbing tails with sharp scissors and carefully sear ends with a flame to prevent fraying.
Cleaning
Prior to removal, mark the location of the hardware for easy re-installation. Place the Band-It in a pillowcase
or sock and tie off. Machine wash and air dry.
This document contains important information that must be passed on to
the user of the product. Do not discard this document before delivery to the
end user.
Fig. 6
Band-It
™
Fitting Instructions
This document contains
important information that
must be passed on to the user
of the product. Do not discard
this document before delivery
to the end user.
Prior to removal, mark the location of
Fig. 7
PN30-123 Rev 10/03
Advertisement
