RightAngle 415NR Installation Instructions

K&A MANUFACTURING
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
VERSION DATED: 10/4/11
4
2
5
ITEM # PART #
1 VARIES TRACK ASSEMBLY
2 VARIES ARTICULATING ARM ASSEMBLY
3 51708 M5 x 18mm SQ/PH/WSHR HEAD WOOD SCREW
4 50232 FRONT STOP
5 50200 10-24 x 1/2 SELF TAPPING MACHINE SCREW
6 VARIES 415/417NR NOTEBOOK TRAY
7 52679 8-32 x 3/8 PHILLIPS TRUSS HEAD MACHINE SCREW 6
8 50267 8-32 SERRATED FLANGE LOCK NUT
INSTRUCTION # 52359

TOOLS REQUIRED FOR ASSEMBLY:

CORDLESS DRILL
#2 PHILLIPS HEAD DRIVER BIT OR
#2 SQUARE HEAD DRIVER BIT
TAPE MEASURE
SQUARE
READ ALL THE
INSTRUCTIONS
BEFORE BEGINNING
1
STEPS 1-4
3
DESCRIPTION
HARDWARE PACK # 52372 & 50531 (TRACK HARDWARE)
415/417NR NOTEBOOK TRAY AND ARTICULATING ARM INSTALLATION
INSTRUCTIONS:
STEP 1: SLIDE THE ARTICULATING ARM 2 OUT OF THE TRACK 1 AND SET IT
ASIDE. DETERMINE THE LOCATION TO MOUNT THE TRACK AND ARTICULATING
ARM. LOCATE THE TRACK SO THAT THE ARM AND TRAY CAN ROTATE LEFT
AND RIGHT AS FAR AS YOU WANT IT TO ROTATE.

STEP 2: EXPOSE THE GLUE DOTS ON THE TOP OF THE TRACK 1

PAPER STRIPS OFF THE TRACK. SEE THE TOP VIEW BELOW. POSITION THE TRACK
SQUARE WITH THE FRONT OF THE WORKSURFACE AND BACK 3/8". PRESS THE
TRACK FIRMLY IN PLACE SO THE GLUE DOTS WILL HOLD THE TRACK ONTO
THE BOTTOM OF THE WORKSURFACE.
IMPORTANT NOTE: THE WORKSURFACE MATERIAL MUST BE COMPATIBLE WITH
THE SCREWS PROVIDED. THE WORKSURFACE MUST BE AT LEAST 1" THICK.
STEP 3: ATTACH THE TRACK 1
SCREWS 3 . DO NOT OVER-TIGHTEN THE SCREWS. USE A LOW TORQUE
SETTING ON THE DRILL.
STEP 4: SLIDE THE ARTICULATING ARM 2
THE FRONT STOP 4 INTO THE FRONT OF THE TRACK. ATTACH IT USING (2) SELF
TAPPPING MACHINE SCREWS
1
QTY.
1
1
6
1
2
1
6
TO THE WORKSURFACE USING (6) WOOD
BACK INTO THE TRACK
5 FROM THE BOTTOM UP AND INTO THE TRACK.
PAPER STRIPS
COVERING
GLUE DOTS
BY PULLING THE
1 . INSERT
PAGE 1 OF 3