Yamaha MG12/4 Owner's Manual page 23

Yamaha mixing console owner's manual
Hide thumbs Also See for MG12/4:
Table of Contents

Advertisement

8 RETURN L (MONO), R Jacks
These are unbalanced phone-type line input jacks. The signal
received by these jacks is sent to the Stereo bus and the AUX1
and AUX2 buses. These jacks are typically used to receive a
return signal from an external effector (reverb, delay, etc.).
These jacks can also be used as an auxiliary stereo
NOTE
input. If you connect to the L(MONO) jack only, the
mixer will recognize the signal as monaural and will
propagate the identical signal on both L and R
jacks.
9 REC OUT (L, R) Jacks
By connecting these jacks to an external DAT recorder or cas-
sette recorder, you can record the same signal that is being out-
put from the ST OUT jacks.
The mixer's ST Master Fader has no affect on the
NOTE
signal output from these jacks. Be sure to make
appropriate level adjustments at the recording
device side.
Connector Polarities
MIC INPUT, ST OUT
LINE INPUT (monaural channels),
GROUP OUT, ST OUT, C-R OUT
AUX1, AUX2
*
INSERT I/O
PHONES
RETURN
LINE INPUT (stereo channels)
* These jacks will also accept connection to monaural phone plugs. If you use monaural plugs, the connection will be unbalanced.
0 2TR IN Jacks
These RCA pin jacks input a stereo sound source. Use these
jacks when you want to connect a CD or DAT directly to the
mixer for monitoring.
NOTE
A POWER Switch
Use this switch to set mixer power to ON or STANDBY.
B AC ADAPTOR IN Connector
Connects to the included PA-20 power adaptor (see page 5).
Pin 1: Ground
Pin 2: Hot (+)
Pin 3: Cold (–)
Tip: Hot (+)
Ring: Cold (–)
Sleeve: Ground
Tip: Output
Ring: Input
Sleeve: Ground
Tip: L
Ring: R
Sleeve: Ground
Tip: Hot
Sleeve: Ground
Front & Rear Panels
You can adjust the signal level using the 2TR IN
control in the Master Control section.
Note that trace current continues to flow while the
switch is in the STANDBY position. If you do not plan
to use the mixer again for a long while, be sure to
unplug the adaptor from the wall outlet.
Use only the PA-20 adaptor included with this mixer.
Use of a different adaptor may result in fire or electric
shock.
INPUT
OUTPUT
Ring
Sleeve
Sleeve
MG16/4, MG12/4
Tip
Tip
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mg16/4

Table of Contents