Advertisement
5.4.
lOWeRING WheelS.
5.4.1.
Remove the locking pin (fig.3) and turn the release valve anticlockwise to lower the vehicle until the tyre is on the ground and no longer
exerting pressure on the rollers.
5.5.
ReMOVING the Skate.
5.5.1.
expand the unit sufficiently to clear the tyre and move it away from the wheel.
6. MaINteNaNce
6.1.
Periodically lubricate the wheels, rollers and the foot pedal lever pivot with acid free oil. lightly grease the four faces of the square section
tube.
6.2.
When the skate is not in use, store fully closed with the locking pin in place, this will minimise ram and piston corrosion.
6.3.
Keep the skate clean. lubricate all moving parts with acid free oil.
6.4.
Before each use, ensure components are in good working order. If any suspect item is found remove skate from service and take
necessary action to remedy the problem.
DO NOt use the skate if you believe it has been subjected to an abnormal load or shock load. If in doubt contact your local
8
service agent. by fully qualified personnel.
6.5.
The oil cylinder is a sealed unit and in principle should not be accessed. To top up the oil remove oil plug (fig.2). The oil level should be
just below the oil plug hole.
WaRNING! only a good quality hydraulic Jack oil, such as SeAleY HYdRAUlIC JACK oIl must be used, DO NOt use brake fluid.
‰
DO NOt overfill as this will render the skate inoperative.
8
IMPORtaNt: no ReSPonSIBIlITY IS ACCePTed FoR InCoRReCT USe oF THe SKATe. Hydraulic products are only repaired by
local service agents. We have service/repair agents in all parts of the UK. DO NOt RetuRN SkateS tO uS. Please telephone 01284
757500 to obtain address and phone number of your local agent. If your skate is under guarantee please contact your stockist.
De-commissioning the skate: If the skate becomes completely unserviceable and requires disposal, draw off the oil into an approved
container and dispose of the skate and the oil according to local regulations.
eNVIRONMeNt PROtectION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, kempson Way, Suffolk Business Park, Bury St edmunds, Suffolk. IP32 7aR
01284 757500
© Jack Sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
Contact your local authorised service agent.
WS680.V2 Issue 1 06/11/18
WS680.V2 Issue 1 06/11/18
www.sealey.co.uk
Advertisement
