Before You Begin - Remington PG155 Manual

ENGLISH

BEFORE YOU BEGIN

Always comb facial hair with a fine comb before you start trimming. Hairs should be dry and
without any waxes or lotions before using the groomer.
TO THIN AND TAPER BEARDS OR MOUSTACHES (Diagram 1)
Attach the trimmer blade.
Place the guide comb on the trimmer blade and select the desired length.
Start trimming under your chin, following your jawline. Work toward your ear and
upper beard line using an upward motion.
TO TRIM EDGE OF BEARD OR MOUSTACHE (Diagram 2)
Attach the trimmer blade.
Hold groomer with cutting blade facing you.
Start with edge of beard/moustache line, and with the cutting blades resting lightly against
your skin, use slow movements to create a beard/moustache line.
TO TRIM SIDEBURNS (Diagram 3)
Attach the trimmer blade.
Comb sideburns in the direction of your hair growth.
Place the guide combs on the trimmer blade and select the desired length
Trim sideburns using a downward motion.
TO TRIM EDGE OF SIDEBURNS (Diagram 4)
Attach the trimmer blade.
Hold groomer with cutting blade facing you.
Trim hairs around the edge of your sideburns using well-controlled movements to trim
hair.
TRIMMING THE NAPE OF YOUR NECK (Diagram 5)
Attach the trimmer blade.
Use your fingers to lift the hair at the base of your head up off the neck. Your index finger
should be covering the roots of the hairs you are lifting to prevent accidental removal by
groomer.
Using your other hand, hold the groomer to the base of your neck with the cutting
unit facing up, and move the groomer up the length of the neck until the unit touches
your finger covering the hair roots at the base of your head. Move the unit slowly when
performing this operation and to keep the hair roots at the base of your head out of the
way of the groomer.
TO REMOVE HAIR FROM EYEBROWS (Diagram 6)
Attach fine trimmer attachment.
Gently guide cutting unit to stray, unwanted hairs along the eyebrow line or protruding
from the eyebrow itself.
To remove the hairs completely lower onto the skin and move over desired area.
Use slow and well-controlled movements.
080710_REM_IFU_PG210C_22L.indd GB_3 080710_REM_IFU_PG210C_22L.indd GB_3
3
05.11.2008 9:21:27 Uhr 05.11.2008 9:21:27 Uhr