Download Print this page
Water Creation F2-0013 Installation Manual

Water Creation F2-0013 Installation Manual

Lavatory faucet

Advertisement

Quick Links

LAVATORY FAUCET INSTALLATION GUIDE
BEFORE YOU BEGIN
1) Shut off water supply.
2) Carefully inspect waste and supply tubing for signs of damage.
3) Replace waste or supply tubing if necessary
A) SPOUT INSTALLATION
1) Remove washer, lock nut and connect tee.
2) Apply plumbers' putty or sealant.
3) Locate mounting hole and insert spout into deck or lavatory.
4) Screw and tighten washers, lock nut onto the shank and secure the spout
5) Screw and tighten the connect tee to the shank.
6) Remove excessive plumbers' putty or sealant
FLOW REGULATOR
METAL WASHER
LOCK NUT
CONNECT TEE
.
TOOLS AND MATERIALS
Adjustable wrench
Basin Wrench
Screwdriver
Pipe Wrench
B) HANDLE VALVE INSTALLATION
1) Place lower plastic washer and lock nut over valve body.
2) Insert valve body from under the sink.
3) Place upper rubber washers and escutcheon on valve spindle.
4) Adjust position of valve body. Secure valve body with lock nut and escutcheon.
5) Place handle onto spindle.
6) Tighten handle with screw.
HANDLE
ESCUTCHEON
RUBBER WASHER
PLASTIC WASHER
LOCK NUT
VALVE BODY
MODEL: F2-0013
Teflon Tape
Flexible Water
Supply Line

Advertisement

loading

Summary of Contents for Water Creation F2-0013

  • Page 1 MODEL: F2-0013 TOOLS AND MATERIALS LAVATORY FAUCET INSTALLATION GUIDE Adjustable wrench Teflon Tape Basin Wrench BEFORE YOU BEGIN Flexible Water Screwdriver Pipe Wrench Supply Line 1) Shut off water supply. 2) Carefully inspect waste and supply tubing for signs of damage.
  • Page 2 C) FLEXIBLE HOSE INSTALLATION MODEL: F2-0013 1) Install flexible hoses onto hot and cold water outlets. 2) Secure hoses with wrench. Do not over tighten. 3) Connect flexible hoses to supply tee. E) SUPPLY CONNECTION 4) Circle the excessive part of hoses as shown in figure below.