Fraser Hill Farm FSSL071A-RD Manual


This product (especially the lamp holder) is
fragile, do not exert too much strength or drop it
during the assembly and use. Be sure to fix it on
the wall securely.

This product is waterproof; but it is necessary to
keep the lamp in the vertical direction to ensure
water drains correctly.

Please assemble it in strict accordance with
the steps and requirements specified in the
instruction to ensure safety and reliability
during the installation.
1) Schematic diagram
2) Component list
No.
1 Lamp top
2 Lamp holder
3 Lamp post (17in）
4 Adapter (12V AC 500mA)
Caution
Name
5
6
7
8
9
10
11
12
13
14
15
3) Assembling steps
Please assemble the product from the bottom to the up,
following the main steps below:
A. Assemble lamp base (9) and square base (10) with 4
screws:
B. Assemble 4 pieces of additional base (7) into a whole,
and then assemble the whole additional base (7) with the
lamp base (9).
Note: The additional base (7) is especially designed to
fasten the street lamp more securely. The additional base
does not need to be installed if the following applies- street
lamp is installed on a flat ground and there is no external
force (such as high wind or man-made interference) to
bring it down or if the street lamp is used outdoor and it can
be fixed on the ground by fastening ground nails. It is to
your discretion on whether to install the additional base (7)
Number
according to the actual condition.
1
1
Screw the 2 lamp posts (3), lamp post joints (12) and
square lamp base (10) together according to the sequence
2
shown in the figure below. Note: Every screw thread must
1
be tightened; otherwise, the lamp posts may lean or get loose!
Extended wire (137in)
Power wire (137in)
(inside lamp post: 59, outside: 78in)
Additional base
Ground nail
Lamp base
Square base
Brand
Lamp post joint
Wreath+ bowknot
Power wire of lamp holder
Screw
Note: 1,2,3,4,5,6 are all wire joints.
1. Install lamp base
2. Install lamp post
1
1
1 set （ 4）
4
1
1
1
1
1 set
1
4+1