Syncing Bpm Effects Using Midi Clock; Displaying An Audio Waveform Or Internal Pattern; Important Kpe-1 Owner’s Manual References - Korg EasyStart KAOSS PAD Entrancer Manual

KPE-1 EasyStart

Syncing BPM Effects using MIDI Clock

1. Select a program in the BPM FX (Audio 50-61, Video 54-60) or BPM PTN (Audio 62-69) group.
2. Enter the MIDI Edit mode by pressing and holding the FUNCTION key and then press the SAMPLE 2 key.
3. Press the SAMPLE 1 key so that it is lit.
4. To store this setting, press and hold the REC/STOP key for a few seconds.
5. Make sure you have the MIDI OUT of your MIDI clock source connected to the MIDI IN of the KPE-1.

Displaying an Audio Waveform or Internal Pattern

1. Press and hold the FUNCTION key and press the SAMPLE 1 key to enter the Pattern Display mode.
2. To select one of the 8 pre-selected patterns press any of the 1-8 PROGRAM MEMORY keys. To change the
pattern that is assigned to that key, press and hold the desired 1-8 PROGRAM MEMORY key and turn the
PROGRAM/BPM knob until the desired pattern is displayed. Effect clip patterns 40-59 will only appear when
you touch the Pad. You can also change the Pattern that is selected by pressing and hold the FUNCTION key
and then turning the PROGRAM/BPM knob.
3. To cancel the display, either press the selected 1-8 PROGRAM MEMORY key again or turn the
PROGRAM/BPM Key.
4. To store the Pattern Display setting press and hold the REC/STOP key for a few seconds while in the Pattern
Display mode.
5. To prevent the Pattern Display from being turned off when you change programs, press and hold the HOLD key
while you turn on the power to the KPE-1. To cancel this setting, just turn off the power to the KPE-1 and turn it
on the normal way.
Important KPE-1 Owner's Manual References
Video and Audio Connection Diagrams
MIDI Functions
MIDI Transmitted and Received Messages
About Demo Mode
4
4 & 5
11
. 12
13