Technical Data - Renkforce RF-4122768 Operating Instructions Manual

Connection to PC or MAC and starting up
• You can also operate the USB board with a PC or MAC.
• In principle, installation and operation is the same as with the Raspberry Pi
If you wish to integrate the USB board into your computer please observe
the special safety instructions of this manual.
Since the screw set is intended only for the attachment to a Raspberry Pi
pay particular attention that the board does not cause a short-circuit, e.g.
due to contact with your PC housing.
If the 5-pin connector (USB_P) is used, follow the instructions in the manual
of your computer or the main board in order to ensure correct pin assign-
ment.
Disposal
Electrical and electronic equipment does not belong in the regular house-
hold waste.
Dispose of the waste product in accordance with the applicable legal regu-
lations.
Technical data
Power supply ...................................... via micro USB 2.0 connector (USB_M), 5-pin con-
Operating voltage............................... 5 V/DC
Connectors (Inputs) ........................... Micro-USB2.0 connector (USB_M); 5-pin USB
Connectors (Outputs) ........................ 4 USB2.0 connectors type A (USB_1_2, USB_3_4);
Supported standards ......................... USB2.0; max. 480 Mbits
Dimensions (W x D x H)..................... approx. 65 x 56 x 20 mm
Weight .................................................. approx. 28 g (only the board)
Operating conditions ......................... +5 °C to +50 °C; 20% to 80% relative humidity
Storage conditions............................. -25 °C to +70 °C; 15% to 90% relative humidity
Supported operating systems .......... Windows
nector (USB_P) or via the external 2-pole connec-
tor (PWR)
connector (USB_P); external 2-pole connector
(PWR) for power supply
2 9-pin connectors each with 2 USB2.0 ports
(USB_P_1_2, USB_P_3_4)
XP from SP1 (only 32 bit), Windows
®
Vista , Windows 7, Windows 8; Windows
™ ® ®
(32 and 64 bit); Windows RT; MacOS, Linux
®
.
®
®
8.1
®
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE.