Fraser Hill Farm Let It Snow Series Manual


This product (especially the lamp holder) is
fragile, do not exert too much strength or drop it
during the assembly and use. Be sure to fix it on
the wall securely.

Please assemble it in strict accordance with
the steps and requirements specified in the
instruction to ensure safety and reliability
during the installation.
1) Schematic diagram
2) Component list
No.
1 Lamp top
2 Lamp holder
3 Lamp post (17in）
4 Adapter (12V AC 500mA)
Caution
Name
5
6
7
8
9
10
11
12
13
14
15
3) Assembling steps
Please assemble the product from the bottom to the up,
following the main steps below:
A. Assemble lamp base (9) and square base (10) with 4
screws:
B. Assemble 4 pieces of additional base (7) into a whole,
and then assemble the whole additional base (7) with the
lamp base (9).
Note: The additional base (7) is designed to fasten the
street lamp more securely. If the street lamp is installed on
a flat ground and there is no external force (such as high
wind or man-made interference), or if the street lamp is
used outdoors and it can be fixed on the ground by
fastening ground nails; there is no need to install additional
base (7). In other words, users can decide whether to
install the additional base (7) according to the actual
Number
condition.
1
1
Screw the two lamp posts (3), lamp post joints (12) and
square lamp base (10) together according to the sequence
2
shown in the figure below. Note: Every screw thread must
1
be tightened; otherwise, the lamp posts may lean or get loose.
Extended wire (137in)
Power wire (137in)
(inside lamp post: 59in, outside: 78in)
Additional base
Ground nail
Lamp base
Square base
Brand
Lamp post joint
Wreath+ bowknot
Power wire of lamp holder
Screw
Note: 1,2,3,4,5,6 are all wire joints.
1. Install lamp base
2. Install lamp post
1
1
1 set （ 4）
4
1
1
1
1
1 set
1
4+1