Advertisement
f'REAL! Blender Cleaning and Sanitizing Instructions
1. Gather required items
2. Thoroughly wash hands
for Cleaning and
with soap and warm water.
Sanitizing. Ensure
f'REAL! Brush is in good
condition. If it is not,
replace it with new one.
Notice: Only use f'REAL!
Brush on f'REAL! Blender
5a. First, the top and
5b. Then the top and
underside of metal cup lid;
bottom of blending disc
and slider;
This is the most important
(Lift cup lid to access
step in the entire process, so
blending disc. Beware of
be sure to do it thoroughly
sharp edges.)
every time.
5f. And last, the interior
6. Close front door firmly.
bottom area of gray plastic
Blender will automatically
blending chamber.
rinse off cleaned
components.
(Do this step last to avoid
possible spreading of drain
area material onto other
cleaned surfaces.)
9. While 2 minute sanitize
10. When sanitize cycle
cycle counts down, clean
ends, remove Sanitizing
f'REAL! Brush and hands
Cup from cup holder, and
again with dishwashing
open front door of blender
liquid to ensure they are as
again.
clean as possible for step
11, and then thoroughly
rinse with warm water.
3. Put 2-3 squirts of
4. Open blender front door
dishwashing liquid into
to access blending chamber
f'REAL! Sanitizing Cup
by pulling on metal tab
and fill cup about half way
located under right corner
with hot water.
of door.
Do not turn blender power
off during cleaning and
sanitizing.
5c. Then the blending
5d. Then the gray plastic
shaft;
blending chamber walls
and front door liner;
8a. Place Sanitizing Cup
Rinse out and then fill
7.
f'REAL! Sanitizing Cup to fill
with properly prepared
line with room temperature
sanitizing solution in
water. Add 4 -6 drops of BTF
blender cup holder.
Iodophor Sanitizer to room
temperature water cup.
Sanitizing solution is still
nearly clear when properly
.
prepared
Use cleaned
12 & 13. Pour remaining
11 a & b.
f'REAL! Brush dipped in
sanitizing solution down
Iodophor sanitizer solution
blender's internal drain
from Sanitizing Cup to
located in gray plastic
thoroughly apply sanitizing
blending chamber. Then
solution to underside and
close front door firmly.
top of metal cup lid like
shown in Step 5a.
5. Using clean f'REAL!
Brush dipped frequently in
Sanitizing Cup with
prepared dishwashing
solution, thoroughly clean
in the following order:
5e. Then the clear plastic
flip up doors - top and
bottom, taking care not to
press them fully open
without supporting them,
as this can cause their
return springs to break off;
8b. Press and hold both
"Less Thick" and "More
Thick" buttons for 5
seconds to begin sanitize
cycle.
14. Rinse f'REAL! Brush
and Sanitizing Cup
thoroughly with hot water.
Allow to dry and save for
next day's use.
Rev k
Advertisement
