Printed in China
WQ54970
U
Portable Player Dock
PDX-50
OWNER’S MANUAL
English
IMPORTANT SAFETY INSTRUCTIONS
CAUTION
RISK OF ELECTRIC SHOCK DO
NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
• Explanation of Graphical Symbols
The lightning flash with arrowhead symbol, within an
The exclamation point within an equilateral triangle is
equilateral triangle, is intended to alert you to the presence of
intended to alert you to the presence of important operating
uninsulated “dangerous voltage” within the product’s enclosure
and maintenance (servicing) instructions in the literature
that may be of sufficient magnitude to constitute a risk of
accompanying the appliance.
electric shock to persons.
IMPORTANT
Please record the serial number of this unit in the space below.
MODEL:
Serial No.:
The serial number is located on the rear of the unit. Retain this Owner’s Manual in a safe place for future reference.
1�
Read these instructions.
10�
Protect the power cord from being walked on or pinched particularly at
2�
Keep these instructions.
plugs, convenience receptacles, and the point where they exit from the
3�
Heed all warnings.
apparatus.
4�
Follow all instructions.
11�
Only use attachments/accessories specified by the manufacturer.
5�
Do not use this apparatus near water.
12�
Use only with the cart, stand, tripod, bracket, or table
6�
Clean only with dry cloth.
specified by the manufacturer, or sold with the apparatus.
7�
Do not block any ventilation openings. Install in accordance with the
When a cart is used, use caution when moving the
manufacturer’s instructions.
cart/apparatus combination to avoid injury from tip-over.
8�
Do not install near any heat sources such as radiators, heat registers, stoves,
13�
Unplug this apparatus during lightning storms or when unused for long
or other apparatus (including amplifiers) that produce heat.
periods of time.
9�
Do not defeat the safety purpose of the polarized or groundingtype plug. A
14�
Refer all servicing to qualified service personnel. Servicing is required
polarized plug has two blades with one wider than the other. A grounding
when the apparatus has been damaged in any way, such as power-supply
type plug has two blades and a third grounding prong. The wide blade or
cord or plug is damaged, liquid has been spilled or objects have fallen into
the third prong are provided for your safety. If the provided plug does not
the apparatus, the apparatus has been exposed to rain or moisture, does not
fit into your outlet, consult an electrician for replacement of the obsolete
operate normally, or has been dropped.
outlet.
We Want You Listening For A Lifetime
Yamaha and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of your equipment by playing it at
a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion - and, most importantly, without affecting
your sensitive hearing. Since hearing damage from loud sounds is often undetectable until it is too late, Yamaha and the Electronic Industries
Association’s Consumer Electronics Group recommend you to avoid prolonged exposure from excessive volume levels. Operate this unit by the
following procedure.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received including interference that may cause undesired operation.
See user manual instructions if interference to radio reception is suspected.
FCC INFORMATION (for US customers)
1�
IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT!
Compliance with FCC regulations does not guarantee that interference will
This product, when installed as indicated in the instructions contained in
not occur in all installations. If this product is found to be the source of
this manual, meets FCC requirements.
interference, which can be determined by turning the unit “OFF” and “ON”,
Modifications not expressly approved by Yamaha may void your authority,
please try to eliminate the problem by using one of the following measures:
granted by the FCC, to use the product.
Relocate either this product or the device that is being affected by the
interference.
2�
IMPORTANT : When connecting this product to accessories and/or
Utilize power outlets that are on different branch (circuit breaker or fuse)
another product use only high quality shielded cables. Cable/s supplied
circuits or install AC line filter/s.
with this product MUST be used. Follow all installation instructions.
In the case of radio or TV interference, relocate/reorient the antenna. If the
Failure to follow instructions could void your FCC authorization to use
antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type
this product in the USA.
cable.
3�
NOTE : This product has been tested and found to comply with the
If these corrective measures do not produce satisfactory results, please contact
requirements listed in FCC Regulations, Part 15 for Class “B” digital
the local retailer authorized to distribute this type of
devices. Compliance with these requirements provides a reasonable level
product. If you can not locate the appropriate retailer, please contact Yamaha
of assurance that your use of this product in a residential environment will
Electronics Corp., U.S.A. 6660 Orangethorpe Ave, Buena Park, CA 90620.
not result in harmful interference with other electronic devices.
The above statements apply ONLY to those products distributed by Yamaha
This equipment generates/uses radio frequencies and, if not installed and
Corporation of America or its subsidiaries.
used according to the instructions found in the users manual, may cause
interference harmful to the operation of other electronic devices.
This equipment compiles with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF
energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated with at
least 20 cm and more between the radiator and person’s body (excluding extremities: hands, wrists, feet and ankles).
NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING
Change or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
FOR CANADIAN CUSTOMERS
This Class B digital apparatus complies with Canadian ICES-003.