Changing The Effect Resolution - Yamaha SU700 Owner's Manual

7.7 Changing the Effect Resolution

Many effects include a resolution setting (note-interval) that determines the effect's
timing. It is important to note that the following points:
• You cannot change the resolution setting using the EFFECT SETUP functions. You
can only change the resolution setting from the EFFECT screens ([EFFECT 1],
[EFFECT 2], [EFFECT 3]).
• Changes you make to the resolution setting while recording is in progress are not
recorded into the song.
• If you wish to record changes in resolution into your songs, you must do this by
storing the resolution settings into scenes. Assume, for example, that you want to
use resolution changes for the effect assigned to Block 1. Proceed as follows.
1) Set up the effect as necessary using the EFFECT SETUP/[SETUP 1] function.
2) Press the EFFECT/[EFFECT 1] button.
3) Press the [NOTE] button (so that the resolution setting is blinking), then turn
the dial to select one of the resolution values you wish to use. Store the results
into a scene—say Scene A. Now turn the dial to select each of the other resolu-
tion values you want to use, and save the results into other scenes—say Scene B
and Scene C.
4) This completes the setup procedure. You can now record resolution changes into
your song by pressing the [A], [B], and [C] scene buttons while recording the
song.
192 Chapter 7 Effects