Advertisement
7. Properly assembled separator components will immediately seal to moderate pressure (100 PSI or less). For maximum
pressure resistance, allow the Loctite 567 or RectorSeal No. 5 thread sealant to cure for 24 hours. PTFE tape typically
does not require curing to achieve maximum pressure resistance.
NOTICE: Over application of torque may cause damage to the Separator or accessory component.
Loctite and Loctite 567 are registered trademarks of Henkel AG & Co. RectorSeal No. 5 is a registered trademark of
RectorSeal Corporation.
Copyright © 2010
8200 N. Austin Ave.
Morton Grove, IL 60053
Tel: (847) 966-3700
Fax: (847) 966-9052
www.bellgossett.com
Advertisement
