elero Aero-868 Installation Instructions

Aero-868/915
Aero-868/915 Plus
28 440.0006, 28 480.0006, 28 440.0906, 28 480.0906
Installation instructions (translation)
66
35
80
▼
135
200
▼
General information
The Aero-868/915 is a wireless light/wind control unit for awnings.
Integrated solar cells provide the power to run the unit.
Radio signals are transmitted between the Aero-868/915 and the
receiver.
Important!
The Aero-868/915/Aero-868/915 Plus only operates in connection
with elero ProLine 2 and Proline radio receivers.
The awning can be operated manually via a hand-held/wall-mounted
transmitter.
This item is not supplied.
Aero-868/915 Plus features
The Aero-868/915 Plus is fitted with an additional battery and an
additional solar cell.
Recommendation: Please use an elero transmitter with manual/
auto switch-over to allow deactivation of the
light function.
Safety instructions
Important safety instructions!
Observe the following instructions.
• Only use unmodified original elero parts.
• Keep persons away from the system's operating
Warning!
range.
• Keep children away from the control units.
• Comply with the regulations in your country.
• The system's operating range must be kept in
view during operation if one or more units are
available for controlling the system.
• The unit contains small parts which could be
swallowed.
• Radio systems transmitting on the same
frequency can interfere with the unit.
• Note that the range of the radio signal is limited
by legislation and adjacent walls and buildings.
80
Note: Horizontal mounting posi-
tion. Light sensor top, wind
sensor underneath.
Note: The housing may show condensation water.
Intended use
The Aero-868/915 may only be used for the control of awnings
and is not suitable for visual protection.
The Aero-868/915 Plus may only be used for the control of
awnings and venetian blinds.
Third-party devices should only be connected after consultation
with your specialised dealer.
• Please ensure that the radio systems are not operated in areas
where interference is a hazard (e.g. hospitals, airports ...).
• The remote control is only approved for units and systems for
which any malfunction of the hand-held transmitter or receiver
would not result in a risk to persons, animals or property,
or if such a risk is covered by other safety devices.
• The operator has no protection whatsoever from interference by
other radio transmitters and devices (e.g. radio systems),
that are normally used on the same frequency range.
• Only use radio receivers with equipment and systems
approved by the manufacturer.
STOP/P button
•
DOWN
button
(sun
Off
symbol)
4
Orange LED
(light value)
Unit function
Light intensity and wind speed are measured at intervals and sent
to the receiver for further processing.
Brightness above
specified value (delay time
approximately 5 - 7 minutes)
Brightness below value
(delay time approximately
15 - 17 minutes)
Wind value above specified
value (wind lock)
The programmed hand-held transmitter can be used to switch the
Aero-868/915 / Aero-868/915's light function on or off. The wind
function is always active.
Manual/auto switch-over has no effect on the function of the travel
buttons.
Transmission
LED
(transmit)
Function
position
UP button
5
(wind symbol)
Red LED
(wind value)
➪ Awning extends (delay time
approximately 5 - 7 minutes)
(orange LED flashes).
➪ Awning retracts after delay
time or remains retracted.
➪ Awning retracts or remains
retracted and is blocked for
around 15 minutes (red LED
flashes).
181122006_EN_0713