icon Audio Stereo 40 MKII EL34 Instruction Manual

Stereo 40 MKII
1 Introduction & Final Inspection
2 Quick Set Up Guide
3 Connecting inputs & outputs
4 Getting the best out of your
amplifier
5 Trouble Shooting
Thank you for purchasing the Stereo 40 MKII. A
great deal of care has been taken in the design,
selection of components and production of this
amplifier. We are sure that you will hear the
difference.
In order to get the best out of your amplifier,
please read the enclosed notes. Even if you are
experienced with hi fi please read the 'quick set
up guide'. Should you be uncertain about
anything to do with your amplifier please contact
us for advice.
Valve (or Tube) amplifiers do exactly the same job
as a solid state amplifier, but they do it differently.
And whilst solid state specifications look good on
paper even quite modest valve amplifiers can
have a richer, more textured sound. Your ears will
have become accustomed to your old amplifier.
Sometimes it may take some hours before your
ears attune themselves to the new sound.
Your source, loudspeakers and room acoustics
will also affect the sound before it finally reaches
your ear. Some people find a small adjustment in
re positioning their speakers can help too. The
weakest link will always affect the final results
icon Audio
Instruction Manual Covering:
Similar Stereo 50 KT88 pictured
Contents
1 Introduction
EL34 version
6 Specifications
7 Bias Checking & Valve
Replacement
8 Guarantee
9 Packing Instructions
when making judgements. Not all recordings are
'equal'! Therefore an amplifier which faithfully
reproduces the input signal will also reproduce
imperfections in the tonal balance and the
recording itself. Setting up and judgements should
be made with a 'clean' well balanced recording.
The Stereo 40 MKII is a push-pull Ultralinear
stereo power amp, capable of running in either
pentode ultralinear or pure triode mode, using the
excellent EL34 valves in fixed bias. The driver and
phase splitting is all triode. The pre-amp is a high
quality 'Passive' circuit using silver audio cable
and an ALPS 'blue' volume control. It is sensitive
enough to be used with all modern source
equipment having an output of 350mv or greater.
Its simplicity coupled with point to point wiring
hand wiring without the use of printed circuit
boards results in an open euphoric sound that is
wonderfully detailed and warm sounding.
This manual also covers the SE & 'ie' model,
where the tape monitor facility & triode circuit
and are omitted.
Page 1