TIE DOWN LongRun 86162 Installation Instructions

Front & Back Pair (1)
Self Tapping Screws (2)
The Glide Ons are to be used on 2x4 bunk board lumber
without any carpeting between the Glide Ons and wood.
1. Remove any carpet or other covering materials from bun
boards. Remove any brackets, screws, staples or other
materials in order to have a clean work surface on top and
both sides of the bunk boards.
2. Position the Bunk Glide Ons so that the two left and the two
right bunks are facing inward and downward (see Fig. 1).
Fig. 1
Front Right Side Bunk Glide On
Front Left Side Bunk Glide On's
WARNING
Bunk Glide On's greatly reduce friction between boat and trailer bunk boards. Winch must be locked and winch
line must be securely attached when launching, loading and transporting boat on trailer. Failure to keep boat
secured at all times to boat trailer can result in serious property damage, personal injury and/or possible death.
Prior to towing - always securely connect winch line, bow chain and transom tie down straps
Instruction Sheet #15390

Part 86162 - Kit contains the following components:

# Qty.
1
2 40

Part 86173 - Kit contains the following components:

# Qty.
WARNING
TIE DOWN ENGINEERING • Atlanta, GA 30336
www.tiedown.com (404) 344-0000
Part # Description
2 86002 4' White Bunk Glide On
(Front & Back Sections)
10630 #10x3/4" Stainless Steel
Self Tapping Screws
Part # Description
1 2 86004 4' Black Bunk Glide On
(Front & Back Sections)
2 40 10630 #10x3/4" Stainless Steel
Self Tapping Screws
Rear
Rear
WARNING WARNING
Front
Rear
Page 1 of 2