Briteq VP-P37.5 Preliminary Setup Instructions

VP-P37.5 preliminary setup instructions

Mechanical screen assembly

- Put the screen together using the quick lock adapters
o Always fix the "VP-P37.5 BRACKET" first: suspended to the ceiling or truss construction.
 Make sure that the ceiling/truss construction can support the complete screen!
 Each bracket can support a column of up to 10 panels. (screen height = 6m)
o Fix the panels in rows: first install 2 rows before you start lock the upper row. This makes it
easier to build the screen together.

Electrical screen assembly

Please refer to the drawing:
The drawing shows the screen from the BACKSIDE! This means that you should place yourself on
the backside of the screen and follow the instructions below:
- Data (video signal) is cabled horizontally: always from left to right, starting from the top row!
o The VP-SCANBOX has 8 outputs:
 Output 1 is connected to the most left panel of the upper row. (panel1 on the drawing)
 Output 2 is connected to the most left panel of the 2nd row. (panel8 on the drawing)
o If the screen is too big for 1 scan box, you can easily connect several scan boxes together,
using the RJ45 in/out connectors and the (blue) CAT6-cable. Configuration of the setup is
done in the setup software.
o Use the small 30cm data cables to daisy chain panels in a row.
Note: VP-SCANBOX supports theoretically up to 12panels (192pixels) per output but to have
good performance you should limit this number to max. 8 panels per output. (ideal = 5 to 6
panels)
- Power (230Vac) is cabled vertically: always from bottom to top.
o Use the small 30cm power cables to daisy chain panels in a column.
Note: a special power cable (VP-POWERLINE 4/30P) is available: it has a length of 4m and
has 4 outputs so you can connect 4 colums and up to 30 panels.

Interface assembly

You need a Windows PC (or laptop) + "VP-PC INTERFACE" + one or more "VP-SCANBOX" to setup
the interface with the screen.
PC  VP-PC INTERFACE:
-
2 lines are needed:
o USB line: use the supplied USB-cable. Important! Before you connect the VP-PC
INTERFACE to your PC, you should install the USB-drivers! (see attached file with drivers)