Acura WF-100 Setup Instructions
  1. Manuals
  2. Brands
  3. Acura Manuals
  4. Controller
  5. WF-100
  6. Setup instructions
Acura WF-100 Setup Instructions

Acura WF-100 Setup Instructions

Hide thumbs
1
2
3

Advertisement

Table of Contents

IMPORTANT: When mounting the WF-100 Controller inside your spa cabinet, the water in your spa
can block the radio signals between the WF-100 and your Wi-Fi router. Be sure to mount the WF-100
so that the spa's water is not between the WF-100 and your Wi-Fi router.
Connect to Acura WF-100 Wi-Fi Controller
1. Turn your Spa OFF.
2. Disconnect spa side control panel from side of control.
3. Open Wi-Fi control box and connect spa side control to connection inside Wi-Fi control box.
4. Connect Wi-Fi control box cable to spa side control panel connection on the Control.
5. Turn your Spa ON.
6. On your smart device (phone, tablet or computer); choose Wireless Networks/WIFI.
7. Scan available networks for "AGI_BOARD_XXX" (XXX is any combination of characters).
8. Select "AGI_BOARD_XXX" network, your smart device will connect to Wi-Fi board's network.
9. Open a web browser (Chrome, Internet Explorer or Edge only). Type 192.168.1.3 into the web
browser's address bar.
NOTE: Make sure that there is nothing else in the address (the browser may put // before the
address, this is wrong). You should see only 192.168.1.3, NOT //192.168.1.3!
10. A web page will open with a large button "Display Scan Results." Push this button.
11. Below the button, a list of available Wi-Fi networks will be shown. From this list, select your
local network (A check will appear to the right of your chosen network). After selecting your
network from the list of available networks, scroll down and verify that your networks SID
(name) is shown.
12. In the "Password" field, enter your local networks password (or WEP Key).
13. Enter your email address in the "Email Address" field.
14. Re-enter your email address (for verification purposes).
15. Scroll down to the "ACCEPT" button and press it.
16. A new information page showing your network information and your email address will appear.
Verify that the information is correct and then press the "JOIN" button.
2954 Rubidoux Blvd.
Riverside, CA 92509
www.acuraspa.com
For questions: sales@acuraspa.com
(192.168.1.3 is your WIFI board's local network address).
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WF-100 and is the answer not in the manual?

Questions and answers

Summary of Contents for Acura WF-100

  • Page 1 IMPORTANT: When mounting the WF-100 Controller inside your spa cabinet, the water in your spa can block the radio signals between the WF-100 and your Wi-Fi router. Be sure to mount the WF-100 so that the spa’s water is not between the WF-100 and your Wi-Fi router.
  • Page 2 17. After approximately one minute, your smart device will timeout on the connection to the Wi-Fi board, exit the browser and verify that you are reconnected to your local Wi-Fi network. NOTE: You must be connected to your Wi-Fi network for all steps below to work. Make sure your smart device is connected to your local Wi-Fi and NOT the AGI_BOARD_XXX network.
  • Page 3 Troubleshooting: If you are at Step 7 above and are never seeing the “AGI_BOARD_XXX” (XXX is any combination of characters), the WIFI board may need to be refreshed back to factory settings. This will force it back to setup mode. 1.

Table of Contents