Table of Contents
Advertisement
OPERATION
Attaching the tool
1. Swivel catch (9) on tool holder (11) outwards.
2. Clean shaft (10) and grease slightly.
3. Insert tool right in.
4. Press catch (9) on tool holder (11) right back.
Only use sharp tools!
Only use tools with perfect shaft (10) to avoid recoil!
Connection
Check before connecting:
1. The mains voltage must be the same as that indicated on the nameplate (12).
2. The electric breaker is operated with 110 V AC (light current).
3. Check whether the necessary fuse is available in the mains supply.
EH 23/110/22
EE 28x160
-A 22
4. The electric breaker is fully insulated and there is therefore no green/yellow PE conductor in the power sup-
ply cable
.
Notes on correct handling
Place the electric breaker with tool on the material in question and switch on by pressing the switch lever.
After a few seconds the electric breaker reaches its full percussion rate.
Exploit the weitht of the electric breaker when working.
Applying great force against the surface being worked does not improve the performance of the tool.
In order to avoid no-load strokes and to ensure easy handling, it is necessary to apply a certain amount of pres-
sure on the handles.
Position the chisel in such a way that the material to be worked can be split. This prevents the tool from jamming
and the demolition perfomance is increased.
8
T00527GB
Advertisement
Table of Contents
