Download Print this page

EZ Hang Chairs Deck Chair Instructions For Assembly

Table of Contents

Download this manual

Instructions for Assembly – EZ HANG Deck Chair

Regarding any questions about our products please contact your sales rep. or visit our

website.

www.ezhangchairs.com

Assembly

Chair parts. Including:

a.Chair

b.Footrest with rope attached (1)  

c.Cup Holder (1)

Happy Bag (1)

e.Hardware pack (1)

Chase lounge can either be extended out or tucked under the chair.

If you desire it tucked under simply use the two clips provided.

When tucked under use regular footrest.

Locate ceiling joist (by Stud Finder or tapping and verifying with a

small nail.) Be sure to locate exact center. Using a 3/16" (3mm) wood

drill bit, drill a hole (approx. 4" (10CM) deep) perpendicular to the

ceiling. Screw in the two supplied eye lags until all threads have

Table of Contents

Do you have a question about the Deck Chair and is the answer not in the manual?

Page 1 Instructions for Assembly – EZ HANG Deck Chair Regarding any questions about our products please contact your sales rep. or visit our website. www.ezhangchairs.com Assembly Chair parts. Including: a.Chair b.Footrest with rope attached (1)   c.Cup Holder (1) d.  Happy Bag (1) e.Hardware pack (1)
Page 2 More rope towards the back results in a more reclined position. Periodically check plastic clips for re-establishing position. Disclaimer   Please note: EZ HANG CHAIRS and all agents or representatives thereof cannot assume responsibility for special, indirect, or consequential damages or contingent liability for use of this product in a manner not expressly intended by the manufacturer.
Page 3 holder. (2) Slip short-sided webbing loop firmly over renowned dowel built-end. Make sure that webbing is taught and flat against the dowel. (Arc of armrest must face inward to the chair). (3) Insert dowel back into holder firmly  (4) Repeat same procedure on right hand rear dowel and on the opposite side.