Table of Contents
Advertisement
Quick Links
Manual Universal-Remote Control 86801
Technical Characteristics
Mains Supply: AC200V‐AC240V / AC100V‐AC120V
Operating Temperature: ‐10 °C to 50 °C
Motor Control receiver RF 315 MHz / 433 MHz
NOTE: RF 315 MHz range is not compatible with RF 433 MHz
Mounting of the Receiver (Recommendations)
Install the receiver with the cables entry pointing downwards to avoid
water infiltration. Do not install the receiver against or sheltered by a
metallic part (it could affect the radio transmission).
Minimum distance between the receiver and the floor: 150cm
Minimum distance between the receiver and the roof: 30cm
Minimum distance between the receiver and the transmitter: 30cm
Minimum distance between two receivers: 20cm
Cabling of the Receiver
The receiver is compatible with all standard A‐OK tubular motors.
Cabling arrangements are shown in the diagram below. Respect the
electrical standards in force as well as the following points:
- Disconnect the mains supply before carrying out any work
- Be careful to avoid static electricity which could damage some
electronic components.
- Use flexible cables
- Ensure that no longitudinal forces act on the cable carriers after
installation
- Do not forget to connect the earth wires
Page | 1
Radio Controlled
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Reflecta 86801
- Page 1 Manual Universal-Remote Control 86801 Radio Controlled Technical Characteristics Mains Supply: AC200V‐AC240V / AC100V‐AC120V Operating Temperature: ‐10 °C to 50 °C Motor Control receiver RF 315 MHz / 433 MHz NOTE: RF 315 MHz range is not compatible with RF 433 MHz Mounting of the Receiver (Recommendations) Install the receiver with the cables entry pointing downwards to avoid water infiltration. Do not install the receiver against or sheltered by a metallic part (it could affect the radio transmission). Minimum distance between the receiver and the floor: 150cm Minimum distance between the receiver and the roof: 30cm Minimum distance between the receiver and the transmitter: 30cm Minimum distance between two receivers: 20cm Cabling of the Receiver The receiver is compatible with all standard A‐OK tubular motors. ...
- Page 2 Page | 2...
- Page 3 Functions LED 1: Operation LED KEY: Program setting button BK1: Selection Switch Motor: rotation UP / DOWN exchange BK2: Selection Switch Embedded switch: UP / DOWN 1 L: Brown 2 R: Black 7 E: Green-Yellow ...
- Page 4 Replacing the battery (1) Open the back board of the emitter with the screwdriver (2) Take out the old battery and then place the new one in (12V23A Battery) (3) Close the back board well with the screw (please take the old battery in the appointed place) Troubleshooting The LED light of the emitter is off or weak ‐> Please check the battery of the receiver The LED light of the emitter is on, but the command cannot be sent ‐> Please check the connection and the receiver or check the program setting The LED lights of the emitter and receiver work well but the motor does not work ‐> Please check the connection and the main power supply of the motor or check the main power supply. reflecta gmbh Merkurstrasse 8 72184 Eutingen i.G. Germany Page | 4...
Need help?
Do you have a question about the 86801 and is the answer not in the manual?
Questions and answers