SyxthSense SSIES-5P Hardware Installation Manual

FEATURES

1. IEEE802.3/ 802.3u/ 802.3x
2. Support auto negotiation speed, F/H duplex mode, and auto send
data control
3. Plug-and-play , auto MDI/MDI-X connection
4. Store and Forward 100M, Switching Process Type
5. Broadcast storm protection
6. Network work state LED indicator
7. 12～48VDC power input Operating temperature ranges from -40
to 75°C
8. Dustproof, rugged industrial design, IP30 protection

PANEL LAYOUT

SSIES-5P series industry Ethernet switches provide 5 TP ports.
Power Input (bottom)
Top Panel
Front Panel

10/100BaseT(X) ETHERNET PORTS

IES205 series have 5 10/100BaseT(X) Ethernet ports(RJ45). The pin
out of RJ45 port display as below, connect by UTP or STP. The
maximum distance is 100m. 100Mbps is used 100Ω of UTP5 , 10Mbps
is used 100Ω of UTP 3,4,5.
RJ 45 port support automatic MDI/MDI-X operation. can connect the
PC, Server, Converter and HUB .Pin 1,2,3,6 Corresponding connection
in MDI. 1→3,2→6,3→1,6→2 are used as cross wiring in the MDI-X port
of Converter and HUB. . 10Base-T/100Base-TX are used in MDI/MDI-X,
the definition of Pins are in below table.
NO. MDI
1 8
signal
1 TX+
2 TX-
3 RX+
6 RX-
4,5,7,
—
8
Note: "TX±"transmit data±, "RX±"receive data±, "—"not use
DIMENSIONS（mm）

POWER SUPPLY CONNECTION

Top view
SSIES-5P series Ethernet Switch has 3-terminal block for power
MDI-X
input(V-,FG,V+), V-, V+ for 12VDC~36VDC power input, FG for
signal
connecting device earth.
RX+
RX-
TX+

INSTALLATION

Before installation, confirm that the work environment meets the
TX-
installation requirements, including the power supply and space and
—
environmental conditions. Avoid in the sunshine, keep away from the
extensive heat or the area where in intense EMI.

DIN-RAIL INSTALLATION

SSIES-5P series can be installed to 35mm DIN-Rail, as follows:
1. Check the DIN-Rail Clip is fitted firmly and 35mm DIN-rail is fitted
firmly.
2. Insert the top of the DIN-Rail into the slot just below the stiff metal
spring. The DIN-Rail clip will insert into place as shown below.

WIRING REQUIREMENTS

Be sure to disconnect the power cable before installing and/or wiring
your Ethernet Switch. Calculate the maximum possible current in each
power wire and common wire. Observe local electrical regulations
Front view