Advertisement
Quick Links
INDIRECT OIL FIRED
SWIMMING POOL
Save these instructions for future reference
Printed in Canada
HEATER
Model:
HMP-03
Manufactured by:
UTC Canada Corporation
ICP Division
3400, Industrial Boulevard
Sherbrooke, Quebec
J1L 1V8
Caution : Do not tamper with
the unit or its controls.
Call a qualified service
technician.
2006/05/24
X40020 Rev. E
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for UTC ICP HMP-03
- Page 1 Model: HMP-03 Manufactured by: UTC Canada Corporation ICP Division 3400, Industrial Boulevard Sherbrooke, Quebec J1L 1V8 INDIRECT OIL FIRED SWIMMING POOL Caution : Do not tamper with HEATER the unit or its controls. Call a qualified service technician. Save these instructions for future reference...
-
Page 2: Part 1 Installation
PART 1 INSTALLATION 1.1) DANGER, WARNING AND CAUTION A QUALIFIED TECHNICIAN MUST INSTALL THE INDIRECT OIL - FIRED SWIMMING POOL HEATER. The signal words DANGER, WARNING and CAUTION are used to identify levels of hazard seriousness. It is important that you understand their meaning. - Page 3 1.2) DELIVERY 1.3.4) Installation of the Outdoor Diffuser Kit Check the SWIMMING POOL HEATER carefully upon delivery for any The HMP-03 swimming pool heater must be installed with the Outdoor evidence of damage that may have occurred during shipping and Diffuser Kit model "GDK", manufactured by ICP (Canada), according to handling.
- Page 4 1.7.2) Outdoor diffuser kit model GDK 1.6) OIL TANK INSTALLATION AND HOOK-UP With the outdoor-diffuser kit no draft regulator is needed and the The oil tank must be installed in accordance with local codes and maximum over fire draft should be +0.045" W.C. after 5 minutes of regulations and CSA Code B139.
-
Page 5: Part 2 Maintenance And Operation
PART 2 MAINTENANCE AND OPERATION We recommend that a qualified technician Check the electrical supply circuits (breakers); start-up and service the swimming pool heater. Check the burner electrode adjustments (refer to the burner instruction manual); Ensure that the heater and the system are Check if the pool thermostat is calling for heat;... - Page 6 2.6) START-UP AT THE BEGINNING OF THE WARNING SWIMMING SEASON Have the chimney and the connecting pipes swept (INSIDE At 60°C (140°F) hot water can produce third INSTALLATION ONLY). degree burns in 6 seconds; at 54°C (130°F) in 30 Have all heating surfaces cleaned if deemed necessary after a visual seconds.
- Page 7 FIGURE 1 DNS-0527 Rev. B Automatic air vent Junction electrical box Outlet water temperature control (setting, max. = 130 Oil burner diff = 10 Pool thermostat Drain valve (at the back of the appliance) ON-OFF switch Ground terminal Green light, correct water level Observation door Red light, low water level Pool heater water outlet...
- Page 8 PART 3 INFORMATION Serial number: Date of installation of the HMP-03: Service telephone - Day: Night: Dealer name and address: START-UP TEST RESULTS Nozzle: Pressure: lb/psi Burner adjustments: Primary air Fine air Draw Assembly Smoke scale: (Bacharach) Gross stack temperature: Ambient temperature: Chimney draft: "W.C.
- Page 9 FIGURE 2 GDK-24 Installation DNS-0524 Rev. A...
- Page 10 FIGURE 3 Typical Piping Arrangement DNS-0525 Rev. A...
- Page 11 FIGURE 4 Wiring Diagram DNS-0518 Rev. B...
- Page 12 PARTS LIST Model : HMP-03 DNS-0540 Rev. B ITEM DESCRIPTION NUMBER ITEM DESCRIPTION NUMBER Tankless coil ass'y B02125 Top front panel ass'y (HMP-03-T only) B02148-02 Gasket, tankless coil B02113 Front door ass'y B02151 Heat exchanger ass'y B02131 Water leak pan B02117 Combustion chamber bottom insulation B00618-04...
- Page 13 PARTS LIST Model : GDK-24 DNS-0557 Rev. A ITEM DESCRIPTION NUMBER COMMENTS Hex washer head self-drilling screw #1/4-14 x 1" F03G010 Stainless steel Diffuser ass'y B01504 Diffuser bracket ass'y B01506 Hex washer head self-drilling screw #8-18 x 1/2" F03G009 Quantity: 4, stainless steel Flue pipe casing B01486 Stainless steel flue pipe...
Need help?
Do you have a question about the ICP HMP-03 and is the answer not in the manual?
Questions and answers