Changing The Hydraulic Fluid And Filter - Toro GreensPro 1260 Operator's Manual

Greens roller
Hide thumbs Also See for GreensPro 1260:
Table of Contents

Advertisement

For example: If the fluid is at ambient-air
temperature, about 24°C (75° F), fill only to the
cold level. If the fluid is about 65°C (150° F), fill
to halfway between the hot and cold levels.
5.
Replace the hydraulic reservoir cap and tighten
it until it is snug.
Important:
Do not overtighten the reservoir
cap.
6.
Wipe up any spilled fluid.
7.
Lower the operator's seat; refer to
Operator's Seat (page
Changing the Hydraulic
Fluid and Filter
Service Interval: After the first 20 hours—Change
the hydraulic fluid and filter.
Every 400 hours—Change the hydraulic fluid
and filter.
Important:
Use only the specified hydraulic fluid.
Other fluids could cause system damage.
Preparing to Change the Hydraulic
Fluid and Filter
1.
Drive or transport the machine to a level surface;
refer to
Transporting the Machine (page
2.
If you run the engine, shut off the engine.
3.
Engage the parking brake.
4.
If the machine is on the rollers, raise it onto the
transport wheels; refer to
onto the Transport Wheels (page
5.
Raise the operator's seat; refer to
Operator's Seat (page
6.
If you run the engine, wait for the engine and
hydraulic system to cool.
Lowering the
23).
16).
Raising the Machine
16).
Raising the
22).
Draining the Hydraulic Fluid
1.
Align a drain pan with a 2 L (2 US qt) capacity
under the hydraulic reservoir
1. Hydraulic-supply hose
2.
Remove the hydraulic-supply hose from the
fitting of the reservoir, and allow the hydraulic
fluid to drain completely
3.
Install the hydraulic hose that you removed in
step 2.
4.
Wipe up any spilled hydraulic fluid.
5.
Dispose of the waste hydraulic fluid according
to local codes.
Changing the Filter
Service Interval: After the first 20 hours—Change
the hydraulic fluid and filter.
Every 400 hours—Change the hydraulic fluid
and filter.
1.
Clean the area around the filter head and
hydraulic filter.
2.
Pack rags under the hydraulic filter
32
(Figure
36).
Figure 36
2. Hydraulic fitting (reservoir)
(Figure
36).
(Figure
g279899
37).

Advertisement

Table of Contents
loading

This manual is also suitable for:

44913

Table of Contents