Advertisement
Updating the documentation
If you have suggestions for improvement or have found any irregularities please contact us
Thank you for purchasing our HS-E420H extension hose and please read this Instruction Manual care-
fully and thoroughly before operating the extension hose of the spray booth in order to have optimal
results.
The HS-E420H can be combined with HS-E420 spray booth for better effects. The paint fog will be
filtered and the harmful gas will be released through the HS-E420H hose out of the window or door. It
will make the air in the studio clean and fresh.
1. Features:
a. Smart, light, easy to combine and dismount
b. The hose length can be extended from 0,7 to 1,7 m and can be bent freely
c. The long, flat exhaust outlet can be pressed from both sides to reach 25 mm for a window or door's
gap.
2. Spare part list
19. Plastic sleeve
20. Soft screw
sleeve
3. Operation directory
1. When using the extension hose please remove one layer of filter net (from spare part 2) There are
two layers of filter net inside the spray booth but only one filter is needed.
2. Remove/ take off the 4 screws and the fan protector from the back of the spray booth HS-E420. See
picture 1
3. Use the 4 screws (that you removed previously) to connect the plastic sleeve (spare part 19) with
the spray booth HS-E420. See picture 2
4. Screw together/join the soft screw sleeve (spare part 20) and the extension hose (spare part 22)
and connect the extension hose to the exhaust port (spare part 23). See picture 3
5. Put the hose clamp (spare part 21) around the soft screw sleeve (spare part 20) and fasten it on the
plastic sleeve (spare part 19). See picture 4.
6. Extend the hose according to your requirement and put the exhaust port out of the window or door.
See picture 5.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
21.Hose clamp
22.
hose
Extension
23. Exhaust port
Seite 5
Advertisement
